Abstract:The corrugation angle of structured packing is an important structural parameter that affects the mass transfer efficiency and pressure drop of distillation process. However, at present, the detailed effects of corrugation angle on the distillation performance of the cryogenic fluids are seldom reported due to the difficulties in conducting cryogenic experiment, which needs to be further revealed for the optimizing of cryogenic structured packing. In this work, a three-dimensional CFD model combing VOF method was established to investigate the flow characteristics of LOX in Mellapak 250 packing under different packing corrugation angles. The effects of corrugation angle on the component mass transfer rate of cryogenic fluids of oxygen and nitrogen were analyzed in detail. Results show that under the combined action of interfacial area, liquid film thickness and liquid residence time, the mass transfer rate decreases by about 30% with the increase of angle from 45 degrees to 60 degrees, while the decrease of wet pressure drop can reach 81.1%, much higher than the reduction ratio of mass transfer rate. It shows 60 degrees packing has application potential and can be used in the middle part of the cryogenic distillation column where mass transfer force is very large, reducing pressure drop loss without substantially sacrificing mass transfer efficiency. 60 degrees packing with higher specific area can also be applied. In addition, it is found that 50 degrees packing can greatly reduce the loss of pressure drop (41.1%) with only a small amount of mass transfer rate loss (8.8%), which shows a good application prospect in cryogenic distillation.

Relationship Between Channel Opening Angle and Dry-Bed Pressure Drop of Structured Packing

Effect of Channel Opening Angle on the Performance of Structured Packings

Dry Pressure Drop Prediction within Montz-Pak Packing with Varied Inclination Angles Using CFD Simulation

Hydrodynamics of New Structured Packings: an Experimental and Micro-scale CFD Study

Investigation of pressure drop in a cocurrent downflow three-phase moving bed

Wall Effects on the Pressure Drop in Packed Beds of Irregularly Shaped Sintered Ore Particles

Numerical simulation for character of fluid flow through packed bed

Experimental study on pressure drop of packed beds with binary sintered ore particle mixtures

Experimental research on structured packing with smaller channel opening angle

Multi-scale study of wet pressure drop model for a novel structured wire gauze packing

A new approach to intensify the structured packing

Liquid–liquid mass transfer and pressure drop behavior in micro‐packed beds with different shaped packings

Numerical Analysis of the Influence of Packing Corrugation Angle on the Flow and Mass Transfer Characteristics of Cryogenic Distillation

Pressure Drop in Packed Beds with Horizontally or Vertically Stratified Structure

Effects of Distribution Channel Dimensions on Flow Distribution and Pressure Drop in a Plate‐Fin Heat Exchanger

Research and development of advanced structured packing in a rotating packed bed

CFD Simulation of Dry Pressure Drop in a Cross-Flow Rotating Packed Bed

CFD Analysis of Wall Effects in Packed Beds with Small Tube-to-sphere Diameter Ratio

A mechanistic model of pressure drop in structured packing

Pressure drop model for the new-type high efficiency packing

Numerical Simulation of Flow and Heat Transfer in Structured Packed Beds with Smooth or Dimpled Spheres at Low Channel to Particle Diameter Ratio