Abstract:Flexographic printing is widely used in the packaging field, but there are still some problems in the printing of flexographic ink on non-absorbent substrates, such as low precision and unstable quality. In this paper, the printing process of flexographic ink is simulated. The interaction of fluid flow, temperature change, and solid deformation in flexographic printing is studied systematically by using the method of fluid–solid thermal coupling for the first time. The process of ink channel formation under static extrusion and fluid–solid thermal coupling was analyzed. The influences of printing pressure, printing speed, ink layer thickness, and ink viscosity on the ink channel were explored. The results show that the printing speed increases and the temperature in the stamping area increases. The printing speed is nonlinear related to the ink flow channel, the influence on the channel is slow at a low speed, the channel increases sharply at a medium and high speed, and tends to be stable at a high speed. When the printing speed is 200 m/min, the ink temperature in the stamping area is 1.5 °C higher than that at the entrance. With an increase in printing pressure, the ink flow channel width showed a trend of decreasing first and then stabilizing, and the pressure was about 0.4 MPa, showing a small fluctuation; the greater the pressure, the higher the temperature of the ink, which will change the performance of the ink and plate, causing adverse effects on the printing belt. The channel width showed obvious nonlinear characteristics with an increase and decrease in ink thickness. When the ink thickness is 30 μm, the deformation of the plate reaches the maximum, and the width of the ink circulation channel is correspondingly the widest. The change in ink viscosity has little influence on the stability of the ink's internal flow rate and temperature field. The research results provide theoretical support for the transfer of ink printing from gravure to flexo printing.

Effects of Smoothness and Roughness of Printing Paper on the Thickness Distribution of Ink Film

Rate-dependent interaction between thin films and interfaces during micro/nanoscale transfer printing

Analysis of the Thermal Stress in Infrared Films

The Glossiness Influence Factor Analysis of Flexographic Printing Water-Based Ink

The Influence of the Characteristics of the Metal Particle in A Thick-Film Ink on Its Screen Printing Aptitude

Trends on Physical Understanding of Bioink Printability

Surface effects on the wrinkles in a stiff thin film bonded to a compliant substrate

Print Quality Evaluation in Paperboard Printing Induced by Changes in Viscosity and Screen Parameters

Evaluation the Printing Fidelity of Glossy Ink-Jet Paper Based on Measure Theory

Study on the quality and inkjet printing effect of the prepared washing-free disperse dye ink

Droplet Morphology Analysis of Drop-on-demand Inkjet Printing

Effect Of Surface Roughness And Reynolds Number On Self-Similarity Of Velocity Profile In The Atmospheric Boundary Layer

The Influence Mechanism of Ink Viscosity on Ink Transfer Rates and Film Defects of the Roll-to-roll Printed Organic Photoactive Layers

Evaluation of printing fidelity of ink-jet paper based on measure theory and fuzzy logic

New advances in the 3D characterization of mineral coating layers on paper.

Numerical Simulation on Ink Transfer Channel of Flexography Based on Fluid–Solid-Heat Interactions

Influence of selected sheet-fed offset printing conditions on primary mottling

The roles of wettability and surface tension in droplet formation during inkjet printing

Effect Of Surface Energies On Screen Printing Resolution

Stability of line shapes in inkjet printing at low substrate speeds

Assessing roughness of extrusion printed soft materials using a semi-quantitative method