Abstract:Coprecipitation is the most commonly used method to synthesize iron oxide nanoparticles (IONPs) due to its low cost and environmentally friendly synthesis process. Recently, several studies have proposed that the coprecipitation formation of IONPs is through the aggregation of initially formed primary particles. However, there are still lack of systematic researches about the room temperature coprecipitation formation process of IONPs under quick mixing mode. Here, a gas/liquid mixed phase fluidic reactor was specially designed, and the influences of reaction time, reaction pH and valence of iron ions on the coprecipitation formation of IONPs in quick mixing mode were studied. The NH3 gas was used as the alkaline reactant. At pH above 10.0, the iron ions promptly hydrolyzed and precipitated to form primary nanoparticles, and then the primary nanoparticles accreted to form Fe3O4 nanoparticles in 2 min 30 s. As the reaction pH increased from 2.5 to 9.5, extremely small particles gradually aggregated to form Fe3O4 nanoparticles. Large Fe3O4 nanoparticles with a mean diameter of ~ 8.1 nm were completely formed at pH 9.5. And a small amount of poorly crystalline intermediate phases including akageneite, ferrihydrite and goethite were observed during this process. When Fe2+ ions were absent during the reaction process, the final products had poor crystallinity and weak magnetic properties. While if only Fe2+ ions were used in the precursor, the sheet-like green rusts generated firstly, and Fe3O4 nanoparticles would gradually form on the surface of green rusts with the partial oxidation of Fe2+ ions. The results of regulating the reaction conditions especially reaction pH indicate that this reaction design can effectively reduce the formation of intermediate crystal phases.

Present Situation of Research Preparation of Iron Oxides in Foreign Countries

Influence of Different Preparation Methods on Crystallisation and Morphology of Fe2o3 Nanoparticles

Synthesis and Characterisation of Transition Metal Iron Oxide Nanocomposite Crystals and Particles Using Wet Chemical Coprecipitation Method

Development of preparation techniques of TiO2 nanoparticles and designation of new coatings

PREPARATION OF IRON-DOPED TITANIA NANOCRYSTALLINE GRAINS AND ITS PHOTOCATALYTIC PROPERTY

Synthesis of Nearly Monodisperse Iron Oxide and Oxyhydroxide Nanocrystals

Preparation of nano-sized iron oxide from steel pickling liquors

The Preparation and Properties of Iron-based Oxygen Carrier Using Sol-Gel Method

Preparation and Characterization of MnFe2O4 by a Microwave-Assisted Oxidative Roasting Process

Solvothermal Synthesis of Monodisperse Iron Oxides with Various Morphologies and Their Applications in Removal of Cr(vi)

In Situ Precipitation: a Novel Approach for Preparation of Iron-Oxide Magnetoliposomes.

Study on the Preparation and Properties of Colored Iron Oxide Thin Films

Dispersion and Physico-Chemical Characterization of Iron Oxide on Various Supports

Facile Methods to Synthesize Nanaosized Iron Oxide Colloidal Dispersion and Its Characterization

Preparation, Surface Functionalization and Application of Fe3O4 Magnetic Nanoparticles

New Sustainable, Scalable and One-Step Synthesis of Iron Oxide Nanoparticles by Ion Exchange Process

Ultrasonic-assisted Preparation of Monodisperse Iron Oxide Nanoparticles

The coprecipitation formation study of iron oxide nanoparticles with the assist of a gas/liquid mixed phase fluidic reactor

Research on Preparation of Nano-porous Lithium Iron Phosphate for Lithium-ion Battery Electrode Materials

Research progresses in preparation methods and applications of zinc oxide nanoparticles

Preparation of Nanoparticles with an Environment-Friendly Approach