Abstract:The solidification behaviours and microstructural characteristics of both ZA27/SiCp composites and monolithic ZA27 alloy were studied by using differential scanning calorimetry, scanning electron microscopy, transmission electron microscopy, electron probe microanalysis, and X-ray diffraction, It was found that there were differences in the transformation temperature and volume fraction of the phases, although the solidification process was almost identical for the composite and the monolithic alloy. The incorporation of SiC particles in the ZA27 alloy led to slight refinement of primary grains and reduced volume fraction of eutectic-like phase. The SiC particles obstructed Zn diffusion in the residual melt during the formation of proeutectic beta phase, but promoted Zn diffusion from alpha (Al) to eta (Zn) phase during eutectoid transformation. During solidification, Cu was mainly segregated in the final solidification regions; Mg was present not only in the matrix but also on SiC particles; and oxide inclusions were mainly distributed around SiC particles, The matrix microstructure for both materials mainly consisted of primary cores of Al rich alpha + eta eutectoid; beta' phase resulting from the eutectoid transformation of the proeutectic beta phase; and Zn rich alpha + eta eutectoid resulting from the eutectoid transformation of the eutectic-like phase. The SiC particles were mainly distributed around the primary grains, Several new phases based on the Al-Zn-Mg-Cu system and interfacial reaction products, including Al21Fe3Si, Cu5Zn8, Mg6Cu3Al7, MgAl2O4, and amorphous oxide inclusions, were identified in the final solidification regions. The nucleation of both primary alpha phase and eutectic-like alpha + eta phase at the surface of SIC particles and their crystallographic orientation relationships were investigated theoretically and experimentally. No distinct crystallographic orientation relationship between the matrix and SiC has been identified, although the mismatch between (0001)(SiC) and (111)(alpha) was calculated to be as small as 7.6%.

Investigation on the Primary Si Phase Solidification and the Properties of Sicw/Al-18si Composites

Solidification behavior of SiCw/Al-18Si composites

Influences of Strontium Addition and Whisker Content on Solidification Behavior of Sic(W)/Al-18si Metal Matrix Composites

Effect of Cooling Rate on the Solidification Behavior and Microstructure of SiC_w/Al-18Si Composites

DSC analysis of liquid volume fraction and compressive behavior of the semi-solid Si3N4w/Al–Si composite

Preparation and mechanical properties of SiC whisker-reinforced alumina

Solidification and microstructure of ZA27/SiCp composite fabricated by mechanical-electromagnetic combination stirring process

Mechanical and Tribological Properties of SiC Whisker‐reinforced SiC Composites Via Oscillatory Pressure Sintering

Effect of Pressure on the Solidification Behavior and Mechanical Properties of SiCp/Al-Mg Composites

Microstructure and Mechanical Properties of Sicp/Mg-Zn-Ca Composites Fabricated by Stir Casting

Microstructure and Thermal Conduction Property of SiCp/Al- Si Composite with High Reinforcement Content

Correlation between phase content and mechanical properties of SiCw- ZTA composites sintered by SPS

The effect of whisker misalignment on the hot compressive deformation behavior of SiCw/6061 Al composites at 500°C

Microstructural Changes of SiCw/6061Al Composite During Compression at Temperatures below and above the Solidus of the Matrix Alloy

Mechanical and tribological properties of SiC whiskers reinforced SiC composites via oscillatory pressure sintering

Mechanical properties and fracture behavior of SiCw reinforced Al–12Ti alloy prepared by bechanical alloying technique

Microstructure of SiC<SUB>w</SUB> reinforced Al–12Ti composites prepared by powder metallurgical technique

Microstructure of SiCwreinforced Al–12Ti composites prepared by powder metallurgical technique

Compressive behaviour of Al-based hybrid composites reinforced with SiC whiskers and SiC nanoparticles

Nano-Phase and SiC–Si Spherical Microstructure in SiC/Al-50Si Composites Solidified under High Pressure

Effect of modification and ceramic particles on solidification behavior of aluminum-matrix composites