Abstract:The group studs arrangement is applied to prefabricated composite beams to significantly improve construction speed. However, contact vibration exists in the unconstrained interface area of the high-speed railway composite beam during the operation period, which degrades the connecting performance of the composite beam and adversely affects the overall structure. In this study, finite element simulations of the vibration of concrete slabs and steel beams in the unconstrained interface area were carried out to obtain finite element models with damage. The effects of vibration damage on the degradation of the studs were investigated by push-out and pull-out tests using finite element simulation of the local specimen model. The macroscopic ontological models of the undamaged and previously damaged group studs were obtained. Compared with the specimen without damage, the ultimate bearing capacity of the pushed-out specimen with damage decreased by 24.8%; the ultimate slip decreased by 15%; and the stiffness decreased by 12.8%. The behavior of the pulled-out specimen with damage was almost the same as that of the specimen without damage. On this basis, a finite element model of the train–track–composite beam coupling system was established. The influence of the degradation of the connection on the coupling system with 300 km/h, 330 km/h, and 360 km/h train speeds was analyzed under the conditions of single-train driving and a two-train rendezvous. In the case of single-train travel, compared with the undamaged composite beam, the mid-span vertical displacements of the composite beams with damage increased by 13%, 8.38%, and 6.2% for train speeds of 360 km/h, 330 km/h, and 300 km/h, respectively; the transverse displacements increased by 24.2%, 15%, and 9.2%, respectively. In the case of a two-train rendezvous, the mid-span vertical displacements increased by 8.8%, 13.7%, and 12.8%, respectively; the transverse displacements increased by 26.4%, 53%, and 24.8%, respectively.

Simulation for the impact between truck and composite viaduct

Simulation For The Impact Between Over-High Truck And Steel-Concrete Composite Bridge

Experimental Study and Numerical Analysis of A Composite Bridge Structure

Research on computational method and dynamic characteristics of traffic vibration of steel bridge

Simulation of Impact between Over-high Truck and Viaduct Based on High Precision Nonlinear Finite Element Analysis

Nonlinear Finite Element Simulation For The Impact Between Over-High Truck And Bridge-Superstructure

Impact Tests of Model RC Columns by an Equivalent Truck Frame

Reduced Models for Simulating Collisions Between Trucks and Bridge Piers

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

COLLISION BETWEEN OVER-HIGH TRUCKS AND BRIDGE SUPERSTRUCTURES: DAMAGE MECHANISM AND IMPACT LOADS

Numerical Investigation on the Dynamic Performance of Steel–Concrete Composite Continuous Rigid Bridges Subjected to Moving Vehicles

Mechanism and Damage Modes of Collision Between Over-high Trucks and Bridge Superstructures

Simulation analysis and control research of long multi-span composite bridge with incremental launching construction

Scaled Model Test for Collision Between Over-Height Truck and Bridge Superstructure

Tests for Collision Between Over-High Trucks and Steel Bridge Superstructures

Influence analysis of group studs stiffness in accelerated construction steel-concrete composite small box girder bridges

Numerical investigation of the dynamic responses of steel-concrete girder bridges subjected to moving vehicular loads

Accurate FEM of Steel-Concrete Composite Box Girder Bridge for Damage Identification Based on Dynamical Experimental Study

Impact Analysis of Composite Sandwich I-Lam System

Dynamic response performance of bridge piers under non-bottom vehicle collision

Numerical Study on the Effect of Interface Dynamic Damage of Steel‒Concrete Composite Beam Bridge Caused by High‒Frequency Impact Load