Abstract:Flow control methods have been gradually applied to improve the flow field characteristics of axial compressors. However, most of the current research is focused on the cascade, and few studies have taken a compressor as the research object. Therefore, a 3.5-stage transonic axial compressor is adopted to explore the characteristics of different flow control schemes. The effects of the micro-vortex generator (MVG), segmented boundary layer suction (BLS), and combined technology (COM) on the MVG and BLS are compared by the numerical simulation method. The research results are summarized as follows. The excessive accumulated low-energy fluid in the blade passage induces the occurrence of a corner stall in the last stage stator of an axial compressor. At this time, the compressor can still work, but the performance has accelerated deterioration. The flow characteristics are effectively improved when the MVG is introduced, the stall margin improvement ΔSM and the peak efficiency improvement Δηe of the last stage are 2.1% and 1.02%, respectively. Moreover, the BLS shows advantages in removing the three-dimensional reverse flow and decreasing the total pressure loss compared with the MVG, the ΔSM of the last stage is 2.69%, and the Δηe is 1.83%. When the combined technology is applied, it shows a significant advantage in delaying the occurrence of a corner stall, and the stall margin of the last stage is improved by 2.71%. Based on a quantitative analysis method using loss sources, the three flow control schemes show significant advantages in reducing the secondary flow loss sources and the wake loss sources. Above all, the BLS shows significant advantages in reducing the total pressure loss, and the COM shows an advantage in expanding the stable operating range. The research results will provide a reference for studies of flow control methods related to reducing flow losses and widening stability margins.

Flow field and performance investigation on an axial-centrifugal combined compressor

Experimental Investigation of the Flow Field Behind the Inlet Guide Vane of the Centrifugal Compressor

Flow Control of Radial Inlet Chamber and Downstream Effects on a Centrifugal Compressor Stage

Flow measurement and simulation of a radial inlet for centrifugal compressor

Comparative Study of the Performance Improvement of an Axial Compressor with a Micro-Vortex Generator and a Suction Slot

Analysis about Performance and Flow Filed of High Mass Flow Multistage Axial-Compressor

Flow Field Improvement by Bowed Stator Stages in a Compressor with Different Axial Gaps under Near Stall Condition

Numerical Investigation of Base-Setting of Stator’s Stagger Angles for a 15-Stage Axial-Flow Compressor

Flow Loss for the Radial Suction Chamber of Centrifugal Compressor Improved Design

Full Annulus Simulation on a Multistage Axial-Centrifugal Combined Compressor

3-D viscous numerical investigation on the overall aerodynamic performance of a transonic axial-flow compressor stage

Application of 3D Blading and Non-Axisymmetric Endwall in a Transonic Compressor

Investigation of the flow mechanisms of affecting compressor performance with axial skewed slots casing treatment

Numerical Investigation of Stator Suction-Type Self-Circulating Casing Treatment Effects on the Aerodynamic Performance of a Single-Stage Axial Flow Compressor

Application of Complex 3D Aerodynamic Layout in Highly Loaded Compressor on Numerical Simulation

Performance Analysis and Improvement of a High Flow Coefficient Centrifugal Compressor

Numerical Investigation of the Unsteady Flow in a Transonic Compressor with Curved Rotors

Design Optimization of Non-Axisymmetric Vane for an Axial Compressor under Inlet Distortion

Three-dimensional flows near rotor tip in an axial compressor II-numerical simulation study

Investigation on Mechanism of Perfomance Improvement for Compressor with New Type of Casing Treatment with Inlet Distortion

An Aerodynamic Design and Numerical Investigation of Transonic Centrifugal Compressor Stage