Abstract:Modern gas turbine endwall is operating in harsher conditions for the application of low NOx combustor. Non-axisymmetric endwall has been extensively studied for aerodynamic performance improvement, because endwall contouring can decrease the pressure gradient between the pressure side (PS) and the suction side (SS) in the blade passage. In addition to the influence of pressure gradient on aerodynamic losses, the vortical structures induced by pressure gradient are also the sources of high heat transfer regions in the passage. Consequently, thermal loads might be reduced by decreasing the pressure gradient thus weakening the strength of the secondary flows. In terms of engineering applications, distribution of thermal load is very important for the design of endwall cooling scheme, and it is necessary to take both aerodynamic and heat transfer performances into consideration for the endwall profile design. In this work, aero-thermal coupled design optimization of a turbine blade endwall was carried out. The endwall contour was obtained by multiplying heights of two curves in the streamwise and pitchwise directions. The streamwise curve was controlled by non-uniform B-spline (NUBS) and the pitchwise one was obtained by employing the sinusoidal function. The optimization method adopted in this research was the multi-objective genetic algorithm (MOGA) coupled with Kriging (KRG) model, which has been validated by benchmark functions. Numerical validation shows that static pressure coefficients on the blade surfaces and the Nusselt number (Nu) on the endwall agree well with the experimental results. The design variables were the endwall profile parameters, and the objective functions were maximizing total pressure recovery coefficient (ξ) at the blade outlet and minimizing the Nu on the endwall. Two optimal cases were selected from the Pareto front and analyzed in detail. It is indicated that the turbine blade aerodynamic performance can be improved while the heat transfer is restrained simultaneously. For the optimal Case I, mass flow-averaged ξ increases by 0.88%, and for Case II, area-averaged Nu reduces by about 7.78%.

Application of 3D Blading and Non-Axisymmetric Endwall in a Transonic Compressor

Numerical Studies on Application of Blended Blade and Endwall Technique on Transonic Centrifugal Compressor

A throughflow-based optimization method for multi-stage axial compressor

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Performance Improvement of Transonic Centrifugal Compressors by Optimization of Complex Three-Dimensional Features

Three-Dimensional Compressor Blading Design Improvements in Low-Speed Model Testing

Optimization and Numerical Investigation of Combined Design of Blade and Endwall on Rotor 67

Effect of Non-Axisymmetric Endwall Profiling on Heat Transfer and Film Cooling Effectiveness of a Transonic Rotor Blade

Performance improvement of a transonic centrifugal compressor impeller with splitter blade by three-dimensional optimization

Blade-end Treatment to Improve the Performance of Axial Compressors: an Overview

Investigation on Aerodynamic Performance of a Centrifugal Compressor with Leaned and Bowed 3D Blades

Aerodynamic Analysis and Three-Dimensional Redesign of a Multi-Stage Axial Flow Compressor

The Effect of End Wall Boundary Layer on Matching and Corresponding Flow Control Technique for Multistage Axial Compressor

Three-Dimensional Aerodynamic Optimization Of A Multi-Stage Axial Compressor

Three-Dimensional Optimization of Blade Lean and Sweep for an Axial Compressor to Improve the Engine Performance

Aero-Thermal Coupled Design Optimization of the Non-Axisymmetric Endwall for a Gas Turbine Blade

Investigation on flow mechanism of an advanced transonic centrifugal compressor with free-form impeller at design and off-design speeds

Investigation of Endwall Treatment and Shock Control in a Five-Stage Axial Compressor

A Novel Airfoil Design Method and its Application to the Optimization Design of a 3-Stage Transonic Compressor

Numerical Investigation of Wall Heating/Cooling Effect on the Transonic Compressor Performance