Abstract:Accurate topology monitoring is a prerequisite for advanced control and optimization of distribution power systems. However, online topology monitoring usually results in high communication facility investments and operating costs. This research proposes an online system topology monitoring method to reduce communication capacity and network traffic by adjusting the smart meter communication interval. Measurements from some critical buses are acquired with short communication intervals. In contrast, other non-critical buses can still maintain much longer communication intervals. We design a three-step angle-free optimization algorithm framework to track system topology and detect branch switching events online. First, we perform load forecasting to obtain active and reactive power pseudo measurements at non-critical buses. Power flow calculations are used to generate voltage pseudo measurements. Then, we perform the weighted least square method and an improved extended Kalman filter to calibrate both pseudo measurements and critical bus measurements. Finally, a topology tracking algorithm based on voltage estimation errors of critical buses is proposed to estimate and correct the current topology. In addition, we propose a critical bus selection method based on historical data statistics. The numerical results on IEEE 33-bus case show that our framework achieves a high online topology monitoring accuracy F1 score of 89.91% with only 10 critical buses. Further tests on a practical 108-bus system in China also demonstrate the effectiveness of our framework.

High Speed and Intelligent Communication Topology Dedicated to Complex Power Electronic System Integration

Novel High Speed and Intelligent Communication Topology Based on PEBB for Power Electronic System Integration

Design Issues Of Building Block Structure Communications For Power Electronic System

Distributed Control with Event-Based Communication and Topology Switching

REAL-TIME MONITORING SYSTEM FOR THE STATES OF POWER NETWORK OVER ETHERNET AND ATM

Study on Networked Control for Power Electronic Systems

Optimal Communication Frequency for Switching Cabled Ocean Networks with Commands Carried over the Power Line.

Distributed Power Control Architecture and System Integration

A Novel Power Line Communication Technique Based on Power Electronics Circuit Topology

Analysis and Design of Power Electronic Building Blocks' Communication Interface

Hybrid Communication Topology and Protocol for Distributed-Controlled Cascaded H-Bridge Multilevel STATCOM

An Improved Topology of Unified Power Flow Controller Based on MMC with Fault Current Limiting

REAL-TIME COMMUNICATION IN REAL-TIME CONTROL AND ANALYSIS SYSTEM FOR POWER SYSTEMS

Topological interactive analysis of power system and its communication module: A complex network approach

New Conceptions for Development of Power Electronics System Integration

Investigation of a Power Network Quality Comprehensive Control Device Based on Novel Cascaded Power Units

HVDC Topology Structure Using Existing Ac Cable Lines for Integrating Renewable Energy Sources

Improved Powered Bus Communication Technique Based on PD‐TDMT for Distributed Power System (DPS)

Traffic Pattern Adaptive Hybrid Electrical and Optical Switching Network for HPC System

Online Distribution System Topology Monitoring With Limited Smart Meter Communication

A Distributed Control Structure And Synchronization Method For Complex Converter Based On Can