Abstract:Controller Area Network (CAN) is the most prevalent communication protocol used in the automotive industry. This in-vehicle network provides a means communication between Electronic Control Units (ECUs) and components within the vehicle. The recent rapid development of connected, electric, and autonomous vehicles expands the complexity and information exchange within CAN and demands an increase in the reliability of the network. Efficient system-level diagnosis functions need to be integrated over the network to ensure for reliability and enhance the ease of troubleshooting. This paper presents a method to identify physical CAN faults such as loss of electrical connections and shorted wires. Fault signatures of predefined physical CAN faults are used to detect and identify the failure modes. The method can identify both permanent and intermittent faults caused by, for instance, damaged connectors and vibrations, respectively. Diagnosis tasks are implemented on in-vehicle module by measuring and processing physical layer voltages of all CAN buses. A real-time data buffer of a predefined size is utilized to calculate health indicators from the physical layer CAN voltages. The health indicators are then compared to predefined thresholds to determine the presence and type of the fault. Compared to ground truth data, the results show that the presented method can identify with high accuracy physical CAN faults including open electrical connection and shorted wires.

Design of electric vehicle controller with dual CAN interfaces

The design of electric motor car's body network based on CAN-bus distributed control

Design and Test of Hardware-in-the-loop Platform for Vehicle Chassis CAN System with Intermittent Open and Short Connection Faults

Design and Application of CAN/LIN Gateway Controller in Automotive Body Network

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

Design of the Control System for A Four-Wheel Driven Micro Electric Vehicle

Distributed control system based on CAN bus for fuel cell/battery hybrid vehicle

Acquisition and Diagnosis Module for Vehicle Information Based on SAE J1939 Protocol

Control Strategy Design and Validation for Ev Based on Rapid Prototyping Platform

CAN Modeling and Simulation of a Hybrid Electric Vehicle Based on OPNET

The Design of the Embedded Bus Controller Based on the Network Monitor System

Design of Fault-Tolerant Automotive Gateway Architecture Using MC9S12XDP512 Microcontroller Device

Automatic Measurement and Control System for Vehicle ECU Based on CAN Bus

Development of the CAN-based Control Unit for Multi-energy Powertrain

Modelling and Simulation of TTCAN for Hybrid Electric Vehicles Based on CANoe

Design of Fuel Cell Vehicle Monitoring System based on CAN Network

CAN Bus-based Vehicle Safety Distance Keeping System

Electric Drive System by Using CAN Fieldbus Technology

Design and development of an extensible multi-protocol automotive gateway

The Development of Embedded System Combining Inner CAN Bus and Outer Network Communication Protocol

Voltage-Based Physical Layer Fault Diagnosis for Controller Area Network