Abstract:The combustion efficiency of the afterburner has an important effect on the overall performance of the ducted rocket. In some difficult working conditions with low incoming air temperature or high flight altitude, it is more difficult to achieve efficient combustion in the afterburner. Therefore, this paper mainly solves the problem of low primary gas combustion efficiency in the afterburner of boron-based ducted rockets when the incoming air temperature is low. The flow field can be improved by optimizing the gas injection mode, so as to improve the combustion efficiency. In this paper, a synergistic impact gas injection device associated with angles of two directions is designed. By controlling the self-impact angle α of gas/gas, and the mutual-impact angle β of gas/air, efficient mixing and combustion is realized. Through numerical simulation, the mixing degree and combustion efficiency, as well as the contours of B 2 O 3 mass fraction are obtained, and the influence regularities and flow field characteristics are analyzed. The selection scheme of the optimal injection device is verified by a ground direct-connected experiment. Finally, through the jet observation experiments, the gas ejection form from the synergistic impact gas injection device is observed. The research of this paper shows that when the mutual-impact angle β is small, the larger the self-impact angle α is, the higher the mixing degree and combustion efficiency will be. When the mutual-impact angle β is large, each self-impact angle α has a high mixing degree and combustion efficiency. When the self-impact angle α is 40° or the mutual-impact angle β is 35°, the mixing can be completed in advance before the gas reaches the afterburner outlet. The higher the average mixing degree, the higher the combustion efficiency. This paper provides an innovative and efficient method for promoting combustion in the afterburner.

Experimental Investigation on Secondary Combustion in Solid Rocket Ramjet

Investigation of RBCC performance improvements based on a variable geometry ramjet combustor

Experimental study on ejector-to-ramjet mode transition in a divergent kerosene-fueled RBCC combustor with low total temperature inflow

Numerical and Experimental Investigation on Dual Shear Coaxial Gas‐Gas Injector

Experimental study on the rocket-ejector system with a throat in the secondary stream

Improvement of Mixing Efficiency in the Combustion Chamber of a Powder-Fuel Ramjet Engine

Effects of the Air Inlet Angle on the Combustion and Ablation Environment of a Hybrid Powder-Solid Ramjet

Effect of the heat release on ejector-to-ramjet dynamic mode transition process in the rocket-based combined cycle engine

Experimental and model investigation on agglomeration of aluminized fuel-rich propellant in solid fuel ramjet

Ejector mode performance improvement of rocket-based combined cycle engine designed for dual-ramjet mode

Experimental Study of the Configuration Optimization of Scramjet Combustor

Effect of Primary Rocket Jet on Thermodynamic Cycle of RBCC in Ejector Mode

Parametric study on mixing augmentation mechanism induced by cantilevered ramp injectors in a shock-induced combustion ramjet engine

Effect of area ratio and heat release method on the Ma∞ = 2-6 operation performance of rocket-based combined cycle engine

Large Eddy Simulation of Combustion Characteristics in a Kerosene Fueled Rocket-Based Combined-Cycle Engine Combustor

Study of Combustion Mode Identification Method on Dual-Mode Solid Rocket Scramjet

Numerical Investigation on Cavity Structure of Solid-Fuel Scramjet Combustor

Effect of synergistic impact gas injection device on secondary combustion in boron-based ducted rockets

Large Eddy Simulation of Effects of Primary Rocket Jet on Low Frequency Combustion Instability in a RBCC Combustor

Effect of Bluff Body Attributes on Afterburner Combustion Characteristics of a Boron Solid Rocket Scramjet

Effects of Scramjet Combustor Configuration on Combustor Performance