Abstract:To explore the mechanical properties of Al alloy under fire or high-temperature environments and ensure its safety in practical applications, this study investigates the failure mechanisms and deformation behavior of Al alloy under tensile loading from a microscopic perspective. Molecular dynamics (MD) simulation method is employed to examine the failure behavior of Al alloy, revealing the failure mechanisms at the microscale and the variations in alloy's mechanical properties under different loads. These findings lay a theoretical foundation for subsequent research on high-temperature resistant Al alloys. The study reveals that Al alloy exhibits a tensile strength of 6.89 GPa at 300 K, with a low occurrence of dislocations during the early stages of tension and a relatively long stage of elastic deformation. As the temperature rises, at 700 K, the tensile strength decreases to 4.42 GPa, representing a reduction of 35.66%. The elastic modulus also decreases from 62.84 GPa to 33.19 GPa. The mechanical properties of aluminum alloys are significantly influenced by temperature changes. The increase in temperature intensifies atomic motion, accelerating the diffusion rate of atoms in the alloy. This leads to thermal expansion of the material and changes in the bonding forces between atoms, thereby affecting the mechanical properties of the material. The yield stress of Al alloy exhibits a positive correlation with strain rate; with an increase in strain rate from 0.001 ps −1 to 0.02 ps −1 , the tensile strength increases from 6.54 GPa to 7.04 GPa. Therefore, appropriately increasing the strain rate can enhance the material's mechanical performance.

Tensile Properties of Three Kinds of Aluminum Alloys at Low Temperature

Tensile Properties of 2519 Aluminum Alloy at Low Temperature

Effects of Temperature and Holding Time on Elevated-Temperature Mechanical Properties of Aluminum Alloy 2519A

Evaluation of mechanical properties for aluminum alloys in low temperature

Experimental Investigation of Mechanical Properties of Aluminum Alloy at High and Low Temperatures

The Anisotropic Property of 7075-T6 Aluminum Alloy under Warm Condition

Investigation of formability of aluminum alloy sheet at elevated temperature

Mechanical properties and microscopic mechanisms of 2219-T6 aluminum alloy under dynamic tension with cryogenic temperatures

Tensile Properties and Deformation-Fracture Behavior of Ti-6Al-4V Alloy at Cryogenic Temperature

Investigation of Tensile Deformation Behavior of 7075-T6 at Elevated Temperatures

High-Temperature Tensile Mechanical Properties and Microstructure of Rolled 6082-T6 Aluminum Alloy Sheets

Study on the tensile properties of Al-Zn-Mg alloy based on molecular dynamics

Tensile Deformation Behaviors of Aluminum Alloy 2219 at High Temperatures from 415°C to 515°C

Tensile Behavior of Ti-5Al-2.5Sn Alloy at Low Temperatures and High Strain Rates

The Study of Microstructure and Mechanical Properties of High Strength and Toughness Casting Al-Cu Alloy

Effect of Low Temperature Heating on Properties and Microstructure of Aluminum Alloy 7150-T77

Tensile Properties of As-Deformed 2A50 Aluminum Alloy in Semi-Solid State

Temperature-Induced Variations in Slip Behavior of Single Crystal Aluminum: Microstructural Analysis

Constitutive equations of high strength aluminum alloy sheet 7B04-T6 under warm tension

Tensile Behavior and Microstructure Evolution of an Extruded 6082 Aluminum Alloy Sheet at High Temperatures

Hot Tensile Behavior of an Extruded Al–Zn–Mg–Cu Alloy in the Solid and in the Semi-Solid State