Abstract:An experimental study is conducted on localized bulging of inflated latex rubber tubes of a range of wall thicknesses and tube lengths, guided by newly emerged analytical results. In the case when the tube has one free closed end that may or may not be subjected to a dead weight, the initiation pressure for localized bulging is determined by a bifurcation condition, and the propagation pressure is determined by Maxwell's equal-area rule. It is shown that after bulge initiation the pressure will decrease monotonically towards, but will never reach, the propagation pressure, and it is when the pressure is sufficiently close to this propagation pressure that rapid propagation of the bulge in the axial direction takes place. It is found that the experimentally observed initiation pressure is around 15% below the theoretical prediction, which is consistent with the fact that bulging initiation is a sub-critical phenomenon and is therefore sensitive to imperfections. The experimentally observed propagation pressure is always very close to the theoretical prediction, which confirms the insensitivity of this pressure to imperfections and demonstrates the predictive power of the material model fitted from our own experiments on equibiaxial stretching. In the other case when the tube is first stretched and then fixed at both ends, bulge initiation takes place in the same manner as in the previous case, but the propagation pressure is no longer determined by Maxwell's equal-area rule. After bulge initiation the pressure will first decrease to a minimum and then rises slowly, and it is on the latter ascending path that the bulge starts to propagate rapidly in the axial direction. A semi-analytical method is proposed for the determination of the minimum pressure. Numerical simulations with the use of the software Abaqus are also conducted to verify the theoretical predictions. (C) 2018 Elsevier Ltd. All rights reserved.

INSTABILITY OF INCOMPRESSIBLE THERMO-HYPERELASTIC TUBES

In-Plane Instability Tests of Bellows Subjected to Internal Pressure and Deformation Load

Experimental Research on Fluid-Elastic Instability in Tube Bundles Subjected to Air-Water Cross Flow

Experimental Research on Fluid-Elastic Instability of Tube Bundles Subjected to Two-Phase Cross Flow

Localised bulging of an inflated rubber tube with fixed ends

Computational instability analysis of inflated hyperelastic thin shells using subdivision surfaces

Characterisation and stability of localised bulging/necking in inflated membrane tubes

Pitchfork and Octopus Bifurcations in a Hyperelastic Tube Subjected to Compression: Analytical Post-Bifurcation Solutions and Imperfection Sensitivity

An Experimental Study of Localized Bulging in Inflated Cylindrical Tubes Guided by Newly Emerged Analytical Results

Buckling of a Stiff Thin Film on a Compliant Substrate in Large Deformation

Three-dimensional postbuckling analysis of thick hyperelastic tubes

Peristaltic Elastic Instability in an Inflated Cylindrical Channel

Prestretch effect on snap-through instability of short-length tubular elastomeric balloons under inflation

Torsion Instability of Anisotropic Cylindrical Tissues with Growth

Nonlinear Instability of Axial Flow Compression Systems

Stability of helical tubes conveying fluid

On deforming a sector of a circular cylindrical tube into an intact tube: existence, uniqueness, and stability

A catalog of pressure drop, deformation profile and tube laws for slender hyperelastic tubes conveying Newtonian flow at steady state

Numerical Simulation of Fluid-Elastic Instability in Heat Exchanger Tube Bundles

Nonlinear fluid-structure interaction analysis of the compression process of inflatable tube structures

Transient compressible flow in a compliant viscoelastic tube