Abstract:The giant magnetoresistance (GMR) and structure was investigated for electrodeposited Co/Cu multilayers prepared by a conventional galvanostatic/potentiostatic pulse combination from a pure sulfate electrolyte with various layer thicknesses, total multilayer thickness and Cu deposition potential. X-ray diffraction (XRD) measurements revealed superlattice satellite reflections for many of the multilayers having sufficiently large thickness (at least 2 nm) of both constituent layers. The bilayer repeats derived from the positions of the visible superlattice reflections were typically 10-20% higher than the nominal <a class="link-external link-http" href="http://values.The" rel="external noopener nofollow">this http URL</a> observed GMR was found to be dominated by the multilayer-like ferromagnetic (FM) contribution even for multilayers without visible superlattice satellites. There was always also a modest superparamagnetic (SPM) contribution to the GMR and this term was the largest for multilayers with very thin (0.5 nm) magnetic layers containg apparently a small amount of magnetically decoupled SPM regions. No oscillatory GMR behavior with spacer thickness was observed at any magnetic layer thickness. The saturation of the coercivity as measured by the peak position of the MR(H) curves indicated a complete decoupling of magnetic layers for large spacer thicknesses. The GMR increased with total multilayer thickness which could be ascribed to an increasing SPM contribution to the GMR due to an increasing surface roughness, also indicated by the increasing coercivity. For multilayers with Cu layers deposited at more and more positive potentials, the GMRFM term increased and the GMRSPM term decreased. At the same time, a corresponding reduction of surface roughness measured with atomic force microscopy indicated an improvement of the multilayer structural quality which was, however, not accompanied by an increase of the superlattice reflection intensities.

Influence of Geometrical Structure on Giant Magneto-Impedance (GMI) Effect in Multilayered Thin-film

Influence of Fe Doping and FeNi-layer Thickness on the Magnetic Properties and GMI Effect of Electrodeposited Ni100−xFex/Cu (x= 0–95) Wires

Optimized Giant Magnetoimpedance Effect In Amorphous And Nanocrystalline Materials

Magnetism and Magneto-optical Effects in Bulk and Few-layer CrI$_3$: A Theoretical GGA + U Study

Length Effect on Giant Magneto-Impedance in Glass-Covered Co-rich Amorphous Wire

Ultra-large Giant Magnetoimpedance Effect by a 2D Square Spiral Amorphous Microwire

INFLUENCE OF GEOMETRY ON GMI EFFECT OF Co-BASED MAGNETIC COMPOSITE MICROWIRES

THEORY OF GIANT MAGNETORESISTANCE IN NONMULTILAYER MAGNETIC SYSTEMS

NUMERICAL STUDY ON GIANT MAGNETO IMPEDANCE EFFECTS IN SOFT MAGNETIC RIBBONS

GMI Measurement System Based on Virtual Instrument Technology

Giant Magnetoelectric Effect at the Graphone/ferroelectric Interface

Simple Theory of Giant Magnetoresistance in a Magnetic Trilayer

Magnetoelectric Coupling In Multiferroic Laminated Plates With Giant Magnetostrictive Material Layers

Giant Magneto-Impedance Effect on Nanocrystalline Microwires with Conductive Layer Deposit

Influence of Varying Metal-to-glass Ratio on GMI Effect in Amorphous Glass-Coated Microwires

Giant magnetoresistance and structure of electrodeposited Co/Cu multilayers: the influence of layer thicknesses and Cu deposition potential

A Theoretical Model Based on Domain Transition Structure for Transition Gmi Behavior in High Frequency

Sensing mechanism modeling of off-diagonal asymmetric giant magnetoimpedance effect in ribbons

Giant Magneto-Impedance and its Applications

Electromagnetic modeling and analysis based on multilayer domain structure for GMI behavior in high frequency

Magnetic interactions and magnetoimpedance effect in FINEMET/SiO2/FePt composite ribbons