Abstract:International Journal of Structural Stability and Dynamics, Ahead of Print. To study the impact of upwarp deformation in the ballastless track on the jumping behavior of the high-speed vehicle, utilizing UM and ANSYS joint simulation, a vertical vibration model of high-speed vehicle on CRTS II slab ballastless track was developed based on the non-Hertz wheel–rail contact model of virtual penetration theory. By using the single-wave cosine curve simulating the characteristics of upwarp deformation in the track slab, we calculated the whole process of wheel jumping. This allowed us to analyze how the amplitude and wavelength of the track slab upward deformation influence the vibration response of the vehicle–track system. Our findings indicate that when a wheel passes through the arch section of the track slab, the entire wheel jumping process consists of distinct stages: "wheel–rail bonding, wheel–rail separation, wheel–rail impact (one or more times), and wheel–rail bonding." As the amplitude of upwarp deformation increases and the wavelength decreases, significant changes occur in several parameters, including the vertical force between the wheel and rail, wheel unloading rate, wheel jump height, frequency, duration, and vertical displacement of the rail. Additionally, when the wavelength is between 2 and 6[math]m and the amplitude is 8[math]mm, the vertical force between the wheel and rail becomes zero, the wheel load reduction rate is one, and the wheel jumps. When the wavelength is less than 3[math]m, the wheel jump height exceeds the flange height, increasing the risk of derailment. Meanwhile, during the first wheel–rail impact, the wheel–rail vertical force and the rail vertical displacement reach their maximum, potentially impacting rail service performance negatively. Finally, compared to the amplitude of the track slab camber deformation, its wavelength has a greater impact on the entire process of wheel jumping. It is recommended that attention be paid to the change in the wavelength of the track slab camber during the maintenance and repair of the ballastless track.

Study on Mechanism of Jumping Rail Beyond Nonlinear Critical Speed

Nonlinear Dynamics Behavior of High-speed Vehicle and Mechanism of Jumping Rail

Dynamic Analysis of Rockfall Impact on Bridges: Implications for Train Safety

Chaotic behavior of jumping rail over hunting for high-speed vehicle

The Bifurcation Analysis of High-Speed Vehicle and Mechanism of Jumping Rail

Development of high-speed railway vehicle derailment simulation - Part II: Exploring the derailment mechanism

Development of High-Speed Railway Vehicle Derailment Simulation – Part I: A New Wheel/rail Contact Method Using the Vehicle/rail Coupled Model

Category of Derailment Mechanism and Prevention for High-Speed Vehicle

Numerical investigation on the dynamic behaviour of derailed railway vehicles protected by guard rail

Dynamic Simulation and Safety Evaluation of High-Speed Trains Meeting in Open Air

Analysis on Critical Speeds of the Rail Vehicle Based on Simpack

Investigation on train dynamic derailment in railway turnouts caused by track failure

A New Semi-Active Safety Control Strategy for High-Speed Railway Vehicles

Study on dynamic performance of high-speed railway vehicle using roller rig and numerical simulation

Study on train running safety in railway switches and sharp curves considering wheel wear evolution

An investigation into post-derailment self-protection mechanisms for railway vehicles

Numerical Investigation into the Critical Speed and Frequency of the Hunting Motion in Railway Vehicle System

Numerical investigation on wheel-rail impact contact solutions excited by rail spalling failure

Numerical and experimental investigation of the wheel/rail interaction and dynamics for a high-speed gauge-changeable railway vehicle

Research on wheel-rail dynamic interaction of high-speed railway under low adhesion condition

The Influence of CRTS II Slab Ballastless Track Upper Arch Deformation on the Wheel Jumping Law of High-Speed Vehicle