Process Investigation of Direct Metal Fabrication Based on Electron Beam Melting

Haitao Liu,Wanhua Zhao,Yiping Tang
DOI: https://doi.org/10.3321/j.issn:0253-987x.2007.11.013
2007-01-01
Abstract:The influence of the process parameters on electron beam melting process is investigated and a mathematic model is set up by linear regression analysis. The results show linear relationships of the width of scanning line with the beam current) accelerating voltage, and scanning speed. The quality of layer produced at R0 equal to 0.5 is better than that produced at R0 less than 0.5. The heat accumulation can be reduced by spiral scanning so that droplet splash is eliminated and high quality layer is obtained. Aiming at the unmelted powders splash from collision between electron and powders, optimized process parameters is selected to pre-heat the powders to obviously reduce the splash. For the balling of scanning line, the process parameters with the ratio of power to scanning speed greater than 0.10 are employed to form a continuous scanning line. One-dimensional scanning line and two-dimensional layer with high performance are obtained by process parameters optimization to lay a foundation for three-dimensional solid object fabrication.
What problem does this paper attempt to address?