Compression Heating Characteristics of Pressure-Transmitting Fluids in High Hydrostatic Pressure Processing

Biao-shi Wang,Bian-sheng Li,Juan Huang,Qing-xiao Zeng,Lin Li
DOI: https://doi.org/10.3321/j.issn:1000-565x.2007.12.026
2007-01-01
Abstract:The compression heating characteristics of three pressure-transmitting fluids such as dioctyl sebacate, water and ethanol in high hydrostatic pressure processing were investigated via the on-line measurement of temperature by inserting the probe into the high-pressure cavity. The results show that (1) The compression heating value of dioctyl sebacate decreases from 0.089 to 0.068°C/MPa with the increase in pressure, while that of water slightly changes from 0.026 to 0.028°C/MPa, and that of ethanol decreases from 0.082 to 0.075°C/100MPa; (2) The influence of pressure on the compression heating value of ethanol is greater than that on water but slightly smaller than dioctyl sebacate; (3) With the increase in the initial temperature, the compression heating value of dioctyl sebacate decreases, while that of water slightly increases; (4) The effect of the initial temperature on the compression heating value of ethanol is greater than that of water, which increases with the mass fraction; and (5) Teflon liner has greater heat preservation effect on dioctyl sebacate than stainless steel liner during the pressure-holding process in different simulated heat loss conditions.
What problem does this paper attempt to address?