Abstract:Partial discharge (PD) is one of the major causes of insulation accidents in oil-immersed transformers, generating a large number of signals that represent the health status of the transformer. In particular, acoustic signals can be detected by sensors to locate the source of the partial discharge. However, the array, type, and quantity of sensors play a crucial role in the research on the localization of partial discharge sources within transformers. Hence, this paper proposes a novel sensor array for the specific localization of PD sources using COMSOL Multiphysics software 6.1 to establish a three-dimensional model of the oil-immersed transformer and the different defect types of two-dimensional models. "Electric-force-acoustic" multiphysics field simulations were conducted to model ultrasonic signals of different types of PD by setting up detection points to collect acoustic signals at different types and temperatures instead of physical sensors. Subsequently, simulated waveforms and acoustic spatial distribution maps were acquired in the software. These simulation results were then combined with the time difference of arrival (TDOA) algorithm to solve a system of equations, ultimately yielding the position of the discharge source. Calculated positions were compared with the actual positions using an error iterative algorithm method, with an average spatial error about 1.3 cm, which falls within an acceptable range for fault diagnosis in transformers, validating the accuracy of the proposed method. Therefore, the presented sensor array and computational localization method offer a reliable theoretical basis for fault diagnosis techniques in transformers.

Study on Location of Acoustic Emission Partial Discharge Detection in Power Transformers

Methodology of Searching the Best AE Sensor Array to Localize PD Sources in Power Transformer

Acoustic localization of partial discharge sources in power transformers using a particle-swarm-optimization-route-searching algorithm

FEM simulation of PD acoustic signal propagation in transformers

Simulation Study on Ultrasonic Signal Propagation Characteristics of Partial Discharge in Transformers

Quantitative Comparison of Partial Discharge Localization Algorirthms on Power Transformers Based on Acoustic Method

Development of Acoustic Emission Sensor Optimized for Partial Discharge Monitoring in Power Transformers

Application of Ultra-high-frequency Partial Discharge Detection in Power Transformers

Review of Partial Discharge Live Detection and Location Technology for Power Transformer

Finite Element Simulation of the Partial Discharge Acoustic Wave Propagation Inside Power Transformers

Partial Discharge Localisation Methodology for Power Transformers Based on Improved Acoustic Propagation Route Search Algorithm

Study of Cross-shaped Ultrasonic Array Senor Applied to Partial Discharge Location in Transformers

Arrival Time Estimation Methodology for Partial Discharge Acoustic Signals in Power Transformers Based on a Double-Threshold Technique

Acoustic Sensors for Monitoring and Localizing Partial Discharge Signals in Oil-Immersed Transformers under Array Configuration

Locating Partial Discharge in Power Transformer by Electrical Method

Study on a Partial Discharge Detection Method for Transformers Adopting the End Shield As UHF Sensor

Phased-ultrasonic Receiving-Planar Array Transducer for Partial Discharge Location in Transformer

Simulation Study on Selection of Install Location for UHF Sensor in Power Transformer

A Novel Partial Discharge Detection Method for Power Transformers on Site Adopting Its Component As Ultra-High Frequency Sensor

Study Of On-Line Monitoring Method Of Partial Discharge For Power Transformers Based On Rfct And Microstrip Antenna

Mutisensor-based Study of Ultra-high Frequency Partial Discharge Location Method for Power Transformer