Abstract:A differential ring voltage‐controlled oscillator (DRVCO) is proposed as a critical block in communication systems, employing Wu active inductors for the first time to achieve low noise, wide tuning range, and low power consumption. Designed in 180 nm CMOS technology, it operates at 2.745 GHz with a tuning range of 2.15 GHz, consuming 1.99 mW. The phase noise is −91.2 dBc/Hz at 1 MHz offset, with a FoM of −156.9 dBc/Hz, covering 0.00072 mm2. A differential ring voltage‐controlled oscillator (DRVCO) is proposed in this paper as one of the critical blocks in communication systems. It consists of four stages of delay cells connected in a chain, creating a ring structure with auxiliary path interconnections. The oscillation frequency of the DRVCO can be controlled by adjusting the tuning voltage that controls the charging current. To achieve the desired performance for wireless applications, the Wu active inductor, which is a low‐noise and high‐quality factor active inductor, is employed in each delay cell for the first time. Using an active inductor provides a wide tuning range and also allows for proper phase noise and low power consumption. The proposed circuit is designed and simulated using standard 180‐nm CMOS technology with a 1.8‐V voltage source (VDD). The circuit is designed to achieve a tuning range of 2.15 GHz with a center frequency oscillation of 2.745 GHz, over the control voltage variation of 1.4 V (0 to 1.4 V). To achieve the desired performance, the circuit consumes an average power of 1.99 mW. It achieves a phase noise of − 91.2 dBc/Hz at 1 MHz offset frequency, indicating effective noise suppression. The figure of merit (FoM) for the circuit is − 156.9 dBc/Hz, representing its overall performance. The final layout of the circuit estimates an area of 0.00072 mm2. Various analyses, including Monte–Carlo simulations, PVT (process, voltage, temperature) variation analysis, and other relevant analyses, have been performed to ensure the reliable performance of the proposed circuit.

A Current Steering Logic Based Ring Oscillator For High Stability And Lower Noise Applications

A Low- Power CMOS Ring- Based Oscillator Using Current Steering Logic Structure

Design and optimization of the ring oscillator based injection locked frequency dividers.

A 0.8 V Low Power Low Phase-Noise Pll

Investigating a novel CMOS ring oscillator with LC-feedbacks

Power And Jitter Optimized Vco Design Using An On-Chip Supply Noise Monitoring Circuit

A Full Swing and Low Power Voltage-Controlled Ring Oscillator

A Subthreshold Biased CMOS Ring Oscillator Model Design in 180-nm Process

A 4 to 5ghz Digitally Controlled Ring Oscillator with 100khz Resolution Using Noise Cancellation Technology in 40nm CMOS.

An 8-11Ghz Low Phase Noise Ring Voltage Controlled Oscillator

A CML Ring Oscillator-Based Supply-Insensitive PLL with On-Chip Calibrations

Closed-Loop, Nonlinearity Analysis And Design Of Dual Tuning, Different Control, High Fom Two Stage Ring Oscillator

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A wide tuning range CMOS differential ring VCO using an active inductor for wireless applications

Design of CML Ring Oscillators With Low Supply Sensitivity

A 62mhz~316mhz Phase-Locked Loop Based on Ring Oscillator for ADC Clock Generator in 0.18m CMOS

A 1mW 5GHz current reuse CMOS VCO with low phase noise and balanced differential outputs

Low Noise Fully Digitally Controlled LC Oscillator with Back-to-back in Series MOS Varactors

A Compact, Low-Power, and Low-Jitter Fractional-N Phase-Locked Loop with a Single-Ended Ring Voltage-Controlled Oscillator in a 12 Nm CMOS FinFET

An accurate ISF-based analysis and simulation method for phase noise in LC/Ring oscillators

Design of Low-noise、Low-power Consumption CMOS CPPLL