Abstract:This brief presents a 0.5-8 GHz CMOS RF receiver front-end (RxFE) tailored for cognitive radio (CR) and digital phased array (DPA) applications. The RxFE comprises a wideband mixer with noise suppression capability, along with a reconfigurable band-pass filter (BPF) designed to adapt to different intermediate frequencies (IFs) and signal bandwidths (SBWs). Additionally, the BPF functions as a programmable gain amplifier (PGA), enabling support for a large dynamic range with fine gain adjustment. The BPF offers a programmable center frequency (CF) range from 250 MHz to 450 MHz with a 5 MHz step, as well as support for tunable passbands from 60 MHz to 240 MHz with 5 MHz resolution. The RF RxFE provides a gain control range of 15-to-55 dB with a 0.5 dB gain step. Fabricated in a standard 55 nm CMOS process, the prototype occupies an area of 2.29 mm2 including pads, consuming 75.6mW power without an on-chip high-IF BPF and 226.8mW with it at 2.3GHz LO input. Measurement results indicate that the prototype achieves approximately 10 ns gain switching time and 350 ns frequency hopping time when driven by an external fast-switching local oscillation (LO) signal, attributed to its high IF architecture. The receiver demonstrates exceptional agility, meeting the stringent requirements of CR and DPA applications.

A Reconstruction Opamp-RC Filter Used in Transmitter of WLAN 802.11 b

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

A Reconfigurable CBP/LP Active RC Filter with Noise-Shaping Technique for Wireless Receivers

A reconfigurable analog baseband for low-power Wi-Fi receiver

A 5.7mw +30dbm IIP3, Tunable Active-RC LPF in 40nm CMOS

A Low Noise, High Linearity CMOS Receiver for 802. 11b WLAN Applications

A Low-Power Monolithic Reconfigurable Direct-Conversion Receiver RF Front-End for 802.11a/b/g Applications

A Reconfigurable Low Power Filter in 65 nm CMOS for Multi-standard Transmitters

A CMOS Programmable Fourth-Order Butterworth Active-RC Low-Pass Filter

Design of Balanced RF Filter for Wireless Applications Using FBAR Technology

An Optimized Receiver RF Front-End

A Reconfigurable Analog Baseband Circuit for Wlan, Wcdma, and Bluetooth

A Highly Linear Lowpass Filter for GSM /WCDMA Receivers

A 2.3mA 240-to-500MHz 6th-order active-RC low-pass filter for ultra-wideband transceiver

A Low Voltage CMOS RF Front-End for IEEE 802.11b WLAN Transceiver

A low-power monolithic reconfigurable direct-conversion receiver RF front-end for 802.1 la/b/g applications

A Five-Order Butterworth Low-Pass Filter with DC Offset Cancellation for WLAN Applications