Abstract:Fault detection and isolation (FDI) logic plays a crucial role in enhancing the safety and reliability, and reducing the operating cost of aircraft propulsion systems. However, it is a challenging problem achieving the FDI task with high reliability. For this purpose, various approaches have been proposed in the literature. In an on-line engine fault diagnoses, two tasks may use Kalman filter to carry out: 1) evaluation of on-line engine state variables to renew the on-board model; 2) diagnoses of online aircraft engine sensor/actuator fault. How to solve the above problems through application of Kalman filter is discussed in this paper. A challenge in developing an on-line fault detection algorithm is making it adaptive to engine health degradation. If the algorithm has no adaptation capability, it will eventually lose its diagnostic effectiveness. To address this problem, the integration of on-line diagnostic algorithms was investigated. The Kalman filter estimates engine health condition over the course of engine’s life. Then the on-board model could be re-constructer based on the estimated values of Kalman filter. After all of the above, A Robust Kalman filter and a bank of Kalman filters are applied in fault detection and isolation (FDI) of sensor and actuator for aircraft gas turbine engine. A bank of Kalman filters are used to detect and isolate sensor fault, each of Kalman filter is designed based on a specific hypothesis for detecting a specific sensor fault. In the event that a fault does occur, all filters except the one using the correct hypothesis will produce large estimation errors, from which a specific fault is isolated. When the Kalman filter is used, failures in the sensors and actuators affect the characteristics of the residual signals of the Kalman filter. While a Robust Kalman filter is used, the decision statistics changes regardless the faults in the sensors or in the actuators, because it is sensitive to sensor fault and insensitive to actuator fault. W. C. Merrill, J. C. Delaat, and W. M. Bruton used a bank of Kalman filters for aircraft engine sensor FDI. This study successfully improved control loop tolerance to sensor failures, which were considered the most likely engine failures to happen under the harsh operating environment. In this study, actuator failure was not considered. In the study done by T. Kobayashi and D. Simon, a fault detection and isolation (FDI) system which utilizes a bank of Kalman filters is developed for aircraft engine sensor and actuator FDI in conjunction with the detection of component faults. The results indicate that the proposed Source: Kalman Filter, Book edited by: Vedran Kordic, ISBN 978-953-307-094-0, pp. 390, May 2010, INTECH, Croatia, downloaded from SCIYO.COM

Troubleshooting soft failure of aircraft engine sensor with sequential probability ratio

Soft Sensor Modeling Based on ISVM and Its Application in PX Fractionation

Sensor Soft Failure Diagnostics Based on Aero-Engine On-Board Adaptive Model

Effective Model Based Fault Detection Scheme for Rudder Servo System

Multi-sensor Fault Diagnosis of Aircraft Engine Based on Kalman Filter Group

A Bank of Kalman Filters and a Robust Kalman Filter Applied in Fault Diagnosis of Aircraft Engine Sensor/Actuator

Analytical Redundancy Design for Aeroengine Sensor Fault Diagnostics Based on SROS-ELM

A sensor fault detection for aircraft using a single Kalman filter and hidden Markov models

Dynamic soft-sensor based on finite impulse response model for dual-rate system

A data-driven hybrid sensor fault detection/diagnosis method with flight test data

Fault Diagnosis for Unmanned Helicopter Based on STF and Wavelet Threshold Denoising

Sensor failure detection and isolation for control system of underwater vehicle

Kalman-Filter-Group Based Aero-Engine Sensors Fault Diagnosis and Verification

Robust In-Flight Sensor Fault Diagnostics for Aircraft Engine Based on Sliding Mode Observers

Fault Detection and Isolation for Sensors on SUH Based on SVR and Wavelet Transform

A Real-Time Engineering Software System for Failure Detection and Isolation of Self-Repairing Flight Control System

Application of Kalman Filters for the Fault Diagnoses of Aircraft Engine

Sensor fault diagnosis of aero-engine based on divided flight status

A pair of two-stage Kalman filters to detect and isolate failures in aircraft with redundant actuators

Time–Frequency Postprocessing Method Based on Generalized S-Transform and Its Application to Aeroengine Rotor System Fault Diagnosis

Parallel crosschecking neural network based fault-tolerant flight parameter estimation and faulty sensor identification