Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Sensor failure detection and isolation for control system of underwater vehicle

Fault Diagnosis and Reconfigurable Control for Underwater Vehicles

Fault Detection and Isolation Methods in Subsea Observation Networks

Effective Model Based Fault Detection Scheme for Rudder Servo System

A Novel Fault Detection and Isolation Technology for Redundant Inertial Measurement Unit

A Fault Detection and Isolation Method for Independent Metering Control System Based on Adaptive Robust Observer

Fault-Tolerant SINS/Doppler Radar/Odometer Integrated Navigation Method Based on Two-Stage Fault Detection Structure

Particle Filter for Fault Diagnosis and Robust Navigation of Underwater Robot

Fault Detection And Isolation For Unmanned Aerial Vehicle Sensors By Using Extended Pmi Filter

Sensor-Fault-Tolerant Operation for the Independent Metering Control System

A Real-Time Engineering Software System for Failure Detection and Isolation of Self-Repairing Flight Control System

Fault Detection and Isolation for Sensors on SUH Based on SVR and Wavelet Transform

Navigation Multisensor Fault Diagnosis Approach for an Unmanned Surface Vessel Adopted Particle-Filter Method

Fault Tolerant Control in Underwater Vehicles

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

A Coupling Diagnosis Method for Sensor Faults Detection, Isolation and Estimation of Gas Turbine Engines

Distributed Sensor Fault Diagnosis for a Formation of Multi-Vehicle Systems

Detection, Isolation and Diagnosability Analysis of Intermittent Faults in Stochastic Systems

Robust fault detection and isolation for uncertain neutral time-delay systems using a geometric approach

Software System for Failure Detection and Isolation of Self-Repairing Flight Control System

Sensitivity-Based Fault Detection and Isolation Algorithm for Road Vehicle Chassis Sensors