Abstract:Differential absorption lidar (DIAL) is widely accepted as a most promising remote sensing technique for measuring the atmospheric CO2, and has been built in many countries to study the global climate change and carbon cycle. However, the imperfect information about CO2 spectrum leads to evident errors in estimating some parameters (such as the absorption cross sections, the broadening coefficients, the optical depth, etc.) which are the critical parameters in retrieving processes of a DIAL, and will eventually result in unacceptable errors of XCO2 retrievals. Coping with that problem, a self-built constant temperature differential absorption spectroscopy system has been set up which can be used to accurately measure the absorption spectrum of carbon dioxide in the band of 1.57 μm.#br#On that basis, the absorption spectra of the pure carbon dioxide are measured respectively at the temperatures from 230 K to 320 K and the pressures from 20 kPa to 100 kPa by the highprecision oscilloscope and wavelength meter. A series of optical depths at absorption peak is respectively calculated at different temperatures and the results show that the optical depth linearly and monotonically changes while the temperature increases from 230 K to 320 K. At the same time, the relations between the corresponding absorption cross sections and temperature are analyzed, showing that the absorption cross sections first increases and then decreases with temperature increasing. The self-broadening coefficients are inferred from the spectral data at the same temperature and different pressures, and the temperature-dependent exponent is calculated. Furthermore, the air-broadening coefficients are calculated by carbon dioxide absorption spectrum data from different mixing ratios and its temperature-dependent exponent is obtained. The temperature-dependent exponent of self-broadening coefficient is 0.644 and the temperature-dependent exponent of air-broadening coefficient is 0.764, which are almost the same as the data in the high-resolution transmission molecular absorption database (HITRAN). The numerical calculation formulae of optical depth and absorption cross section are verified through these results.#br#Those parameters supplement the widely-used HITRAN database. Moreover, quantitative analysis is conducted to explore the influences of temperature and pressure on CO2 spectrum, thereby establishing a function for modeling the differential absorption optical depth and the absorption cross-section. The above results have already been used in China's CO2-DIAL and lay a foundation of accurate retrieval. It is believed that other similar CO2-DIAL of which operating wavelength is around 1.572 μm would also benefit from those newly measured parameters.

FTIR Measurement and Analysis Based on the Selection of Optimized Spectral Band

Research on analyzing atmospheric transmittance based on infrared radiation measurements

[Application of FTIR Spectra Fitting Method in Retrieving Gas Concentrations].

Remote Sensing of Atmospheric Trace Gas by Airborne Passive Ftir

Research on the Influence of Infrared Spectral Resolution on Gas Quantitative Analysis

Quantitative Analysis of Multi-component with FTIR and Its Application

Passive remote sensing of VOC in atmosphere by FTIR spectrometry]

Fourier Transform Infrared Greenhouse Analyzer for Gases and Carbon Isotope Ratio

Quantitative Analysis Method for the Fourier Transform Infrared Spectroscopy of Gases

Quantitative Analysis of Accuracy of Concentration Inversion under Different Temperature and Pressure

Application of Long Open Path Ftir System in Ambient Air Monitoring

Retrieval Algorithm of Quantitative Analysis of Passive Fourier Transform Infrared (FTRD) Remote Sensing Measurements of Chemical Gas Cloud from Measuring the Transmissivity by Passive Remote Fourier Transform Infrared

Study on the Quantitative Analysis of Multi-Component Toxic Gases Based on FTIR

Complex Greenhouse Gas Measurement On-Line And In Situ Using Ftir Spectrometer

Influence Factors of Quantitative Analysis Precision of Greenhouse Gases and Carbon Isotope Ratio Based on Infrared Spectroscopy

Air Quality Detecting Based on FTIR and Spectrum Substraction

Study of Radiation Calibration Based on Airborne FTIR Spectrometer

Measurement of Absorption Spectrum Around 1.572 Μm

Analysis on Influence Factors for Transmission Measurements of Absorbing and Scattering Media Based on the Internal Optical-Path of FTIR Spectrometer

[Measurement and Application of CO2 Spectroscopic Parameters Near 2.0 Μm].

Study on temperature dependence of the greenhouse gases and carbon isotope ratio spectral analysis