Abstract:The separation of the gas and liquid in the gas-liquid cyclone separator is achieved through the swirling flow. The liquid film flow characteristics and the dynamics of droplets impacting the liquid film are very important for the separation performance, but these phenomena have not been well understood in the swirling flow. In this work, an experiment was conducted to investigate the liquid film flow and droplet impingement in the annular channel of the gas-liquid cyclone separator. Three regions of the annular channel could be divided based on the film flow patterns, which were the inlet region, the annular region, and the outlet region; and four typical droplet impact outcomes could be observed, which were splashing, coalescence, bouncing, and jet breakup. According to the characteristics of the liquid film and the outcome of droplet liquid film impingement, if the droplet splashing in the inlet region could be weakened and the length of the annular region was lengthened, it would be beneficial for gas-liquid separation. The impact outcomes were shown to undergo a transition from bouncing to coalescence as the droplet Weber number increased. Droplet coalescence was affected by the disturbance of gas flow and the evenness of the liquid film, so when the superficial velocity of the gas flow was fixed, the transition boundary was constant whatever the liquid volume fraction in the channel, and when the Reynolds number of the gas flow increased, the transition boundary of droplet Weber number increased first and then decreased. This work may provide a basis for a comprehensive understanding of the liquid film flow pattern and droplet behavior in the cyclone separator, and the results have the potential to be applied in other multiphase studies.

Droplets Statistics Model for Water Entrainment in The Separation Zone of the Compound Bubbling Chamber

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Entraining Liquid Problem in a New Type of Scrubbing-Cooling Chamber

Numerical study of gravity separation of droplets in gas-liquid separation space of scrubbing-cooling chamber

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Numerical and experimental investigation on droplet entrainment mechanism and closed equations of two-fluid model

Numerical Investigation on Droplet Collision Phenomena in Moisture Separators Using Population Balance Model under Lagrangian Framework

Local Distributions of Bubble Velocity and Interfacial Area in the Slender Particle-Containing Scrubbing–Cooling Chamber of an Entrained-Flow Gasifier

Experimental Investigation of Oil Film Flow and Droplets Behavior in the Annular Channel of a Cyclone Separator

Analytical Solution of Gravity Separation Model (gsm): Separation of Water Droplets from Vapor in Submerged Combustion Evaporator

A new gas-liquid mass transfer enhancement method for a multi-downcomer sieve tray: Bubble breakup by falling droplets

Simulation on spray evaporation processes in Multi-spout bed by modified impinging wall method

Numerical Prediction of the Outcomes of Binary-Droplet Collision in Steam-Water Separator

NUMERICAL SIMULATION AND EXPERIMENTAL STUDY ON EVAPORATION CHARACTERISTICS IN MULTI-SPOUTED BED

Numerical Study of Gas-Liquid Flow in Dual-Contact-Flow Absorber with One-Dimensional Two-Way Coupled Model

Study of Droplets Behaviors in the Steam-Water Separator with Monte Carlo Method

Numerical analysis of a novel cascading gas-liquid cyclone separator

Development of a Coalescence Model in Gas–solid Fluidized Bed for the Population Balance Equation