Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Study on Limited Jerk Control for Eliminating Residual Vibrations of Flexible Systems

Optimal Limited-Jerk Time-Delayed Filter for Restraining Residual Vibration of Flexible Systems

Application of force limited control in vibration test

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Improved Sliding-Mode Control for Servo-Solenoid Valve with Novel Switching Surface under Acceleration and Jerk Constraints

Vibration Suppression of a High-Speed Macro-Micro Integrated System Using Computational Optimal Control

LIMITED-JERK OPTIMAL TIME-DELAYED FILTER SUPPRESSING RESIDUAL OSCILATION OF CRANE PAYLOAD

Active vibration control of a flexible beam based on experimental modal analysis

Combining Input Shaping and Adaptive Model-Following Control for Vibration Suppression

Vibration suppression of flexible parallel manipulator based on sliding mode control with reaching law

Active Vibration Control of a High-Speed Flexible Robot Using Variable Structure Control

Vibration Control for Flexible Spacecraft Using Multi Impulse Robust Input Shaper and Optimal Control Method

Controllable Trade-off Between Performance and Constrained Input for Vibration Suppression in Flexible Space Structures

Optimal Switching Time Control for Suppressing Residual Vibration in a High-Speed Macro-Micro Manipulator System

Integrated Fixed Time Sliding Mode Control for Motion and Vibration of Space Robot with Fully Flexible Base–Link–Joint

Simultaneous Optimization of Actuators' Configuration and Vibration Control in Ultra-Precision Motion Systems with a Time-Varying Performance Location

Vibration control of a high-speed flexible parallel mechanism based on model predictive control

Vibration Control of a Constrained Two-Link Flexible Robotic Manipulator with Fixed-Time Convergence

Beneficial Performance of A Quasi-Zero-Stiffness Vibration Isolator with Time-Delayed Active Control

Vibration suppression of a beam using variable structure control with disturbance observer

Vibration Suppression of a Flexible-Joint Robot Based on Parameter Identification and Fuzzy PID Control