Abstract:With the recent advent of integrated PET/MR hybrid systems, the need for simultaneous PET and MR phantom measurements arises. Phantom fluids that are used in stand-alone MR systems, especially in larger phantoms and at a high magnetic field strength, are not necessarily applicable in PET imaging and vice versa. In this study, different approaches to fluid selection were considered and systematically evaluated with respect to their usability for simultaneous PET/MR phantom imaging.METHODS: Demineralized water, water with increased electrical conductivity, a water-oil emulsion, and monoethylene and triethylene glycol were investigated in MR and PET measurements using the most common PET tracer (18)F-FDG. As an alternative to (18)F-FDG, a modified PET tracer ((18)F-fluoride Kryptofix 222 complex) was investigated toward its ability to dissolve in pure oil, which provides good signal homogeneity in MR imaging. Measurements were performed on a 3.0 T integrated PET/MR whole-body system using a National Electrical Manufacturers Association quality-standard phantom.RESULTS: All tested fluids dissolved the radiotracer (18)F-FDG homogeneously. Regarding their suitability for MR at 3.0 T, all fluids significantly improved the homogeneity compared to pure water (increase of excitation flip angle within the tested phantom by a factor of 2.0). When the use of (18)F-FDG was preferred, triethylene glycol provided the best compromise (flip angle increase by a factor of 1.13). The potential alternative tracer, (18)F-fluoride Kryptofix 222 complex, dissolved in pure oil; however, it is not optimal in its tested composition because it accumulates at the bottom of the phantom during the time of measurement.CONCLUSION: This study provides a systematic approach toward phantom fluid selection for imaging a given quality-standard body phantom--and phantoms of comparable size--at 3.0 T. For simultaneous PET/MR scans using the standard tracer (18)F-FDG, an alternative fluid to water and oil is proposed that serves as a viable option for both imaging modalities. Nevertheless, when water is preferred, ways to improve MR image homogeneity are presented. The tested alternative PET tracer enables the use of pure oil in combined scans, but the tracer composition needs to be optimized for phantom measurement applications.

Design of Optical Pumping Noble Gas MRI Phantom

Nanoporous hollow fibers as a phantom material for the validation of diffusion magnetic resonance imaging

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A multi-modality medical imaging head and neck phantom: Part 2. Medical imaging

Proton/Deuterium Magnetic Resonance Imaging of Rodents at 9.4T Using Birdcage Coils

Troubleshooting and Quality Assurance in Hyperpolarized Xenon Magnetic Resonance Imaging: Tools for High-Quality Image Acquisition

Subwavelength Dielectric Waveguide for Efficient Travelling-Wave Magnetic Resonance Imaging

Hardware and Software Setup for Quantitative 23Na Magnetic Resonance Imaging at 3T: A Phantom Study

Systematic Evaluation of Phantom Fluids for Simultaneous PET/MR Hybrid Imaging

Toward Ultra‐high‐quality‐factor Wireless Masing Magnetic Resonance Sensing

Design of a Phantom Mimicking Rectal Lymph Nodes for Magnetomotive Ultrasound

Fabrication of Customizable Intraplaque Hemorrhage Phantoms for Magnetic Resonance Imaging

3D-printed Shepp-Logan phantom as a real-world benchmark for MRI

A high-field 3He Metastability Exchange Optical Pumping polarizer operating in a 1.5 T medical scanner for lung MRI

Magnetization and Diffusion Effects in Nmr Imaging of Hyperpolarized Substances

Phantom for quantitatively measuring MRI artifact

Sequential Scan-Based High-Resolution 3-D Open-Sided Magnetic Particle Imaging System

MR Imaging with Hyperpolarized Noble Gases of Lung

Advancements, Challenges, and Future Prospects in Clinical Hyperpolarized Magnetic Resonance Imaging: A Comprehensive Review

MRI compatibility study of an integrated PET/RF-coil prototype system at 3T

High-fidelity anatomical phantoms for MRI practical training