R-z plane spatial critical current inhomogeneity-induced mechanical response of GdBCO superconducting bulks during field cooling magnetization
Juntong Hu,Wenjiang Yang,Difan Zhou,Peng Zhao,Fuwen Deng,Juzhuang Yan
DOI: https://doi.org/10.1088/1402-4896/ad2d4b
2024-02-27
Physica Scripta
Abstract:Benefiting from the high critical current density (Jc), single-grain (RE)BCO (where RE = rare earth or Gd) bulks are capable of trapping over 17.6 T magnetic field which is crucial for the application of bulk superconductors. Nevertheless, during field cooling magnetization (FCM), the large mechanical stress induced by Lorentz forces may lead to fracture behavior in the brittle ceramic nature of (RE)BCO materials. Most previous numerical models that adopted simplified homogeneous Jc had difficulty reflecting the real stress/strain situation in high temperature superconductor (HTS) bulks. Based on the proposed modified Jirsa model considering r-z plane Jc inhomogeneity, we investigate the mechanical response of GdBCO bulks manufactured by top-seeded melt growth (TSMG) process. A 2D axisymmetric electromagnetic-thermal-mechanical coupled model is implemented to take into account the dependence of Jc upon mechanical deformation. The simulation results show the electromagnetic-thermal-mechanical response of the r-z plane inhomogeneous Jc model is significantly lower than that obtained by the homogeneous Jc model. This confirms Takahashi's speculation (K Takahashi 2019 Supercond. Sci. Technol. 32 015007) about the mismatch between experimental data and the simulation results of homogeneous Jc model, and suggests the stress levels in the bottom plane of HTS bulk are overestimated by the previous homogeneous Jc model. On top of that, the overall stress level of GdBCO bulk is strongly determined by the magnitude and position of the Lorentz force load, and the stress distribution of inhomogeneous Jc model is mainly concentrated in high Jc regions near top surface, instead of being symmetrically distributed along the z-axis as in homogeneous Jc model. The mechanical response of stainless steel reinforced GdBCO bulk under two different constraint conditions was analyzed and compared. Finally, the coupling effect between the fracture strength variability caused by defects and cracks and the trapped field in GdBCO bulks with r-z plane Jc inhomogeneity is further studied. This study may provide a relatively realistic mechanical response of HTS bulk during FCM, and a novel design consideration for its mechanical reinforcement.
physics, multidisciplinary