Abstract:The vector network analyzer (VNA) has been widely applied in the measurement of microwave devices with wide frequency bandwidths. Particularly, the measurement of the complex reflection coefficients of waveguide devices is its important applications. Due to connecting the devices to be measured to the VNA with a coaxial-to-waveguide adaptor, the systemic error caused by the defect of the coaxial-to-waveguide adaptor will be introduced. For solving the problem, the calibration of the coaxial-to-waveguide adaptor is needed by connecting a series of known standard components to the measurement system. Subsequently, the systemic error can be obtained by analyzing the measurement results of the known standard components. The traditional calibration method uses three standard components, i.e., a load, a short circuit, and an offset short with known phase. However, with the traditional calibration method, the exact location of the short plane is difficult to be determined at the range of millimeter wave frequencies. In this paper, a novel calibration procedure using a matched load and an adjustable shorter with several unspecified phases is proposed to reduce the systemic error caused by the adaptor. The advantage of this method is only to define one shorter plane as reference plane. During the calibration process, the position of the piston is unnecessary to be recorded. More offset shorts are used; more accurate de-embedding effect can be get. The proposed calibration method is especially fitted to the system calibration at the range of millimeter wave frequencies, where the accuracy of the system calibration is very sensitive to the position of standard short plane. The measured results show that the module of corrected S-11 of a shorter is less than 0.1 dB with linear phase delay and the corrected S-11 of a matched load is below -40 dB. The results are much more accurate than the raw readings, 1.3 dB and -15 dB respectively, before the adaptor calibration. It is also shown that the technique is resistant to the error of the adjustable shorter position and is easy to implement.

Calibration Coefficient Model of coaxial calibration kit for network analyzer

A Coaxial-to-waveguide Adaptor Calibration Method using an Adjustable Shorter with Unspecified Phases

A calibration method for vector network analyzers using a line and three or more offset-reflect standards

Adaptor Calibration Using A Matched Load And An Adjustable Shorter Without Specified Phases

Multiport Network S-parameter Restoration and Calibration with 2-Port Network Analyzer

Methods of Correcting for Variations in Cable in Microwave Measurement

A New Self-calibration Method of the Six-port Measurement System

Design of a calibration network of TD-SCDMA smart antenna array

A Novel Method for Measuring Beam Coaxiality Based on Camera Calibration

Accuracy Improvement for Scattering-Parameters Evaluating of Microwave Coplanar Probe Using One-Port Two-Tier Multi-TRL Calibration Method

An improved method for TRL calibration

A New Method Based on the Construction of Hypothetical Symmetrical Networks for Fixture Calibration in Network Analyzers

Measurement Error Detection for Calibration Standards Based on Cluster Analysis

Measurements of Planar Microwave Circuits Using an Improved Trl Calibration Method

A Simple and Effective Method for Polarization Scattering Parameter Measurement and Calibration Using Vector Network Analyzer

Symmetric-Reciprocal-Match Method for Vector Network Analyzer Calibration

A novel vector network analyzer

Accurate channel model of coaxial cable network and its application in fault location

Design Theory of Accurate Calibration Kits for the Six-Port Reflectometer Based on the Different Power Measurement Error

One-Port Direct/Reverse Method for Characterizing VNA Calibration Standards

A hybrid probe-tip calibration for multiport vector network analyzers