Abstract:This paper investigates the vibration patterns, i.e. rigid motions of shaft and elastic deformation of support structures, of fan rotor system in aero-engine, which differs from traditional flexible rotor systems, and together with its shaft transverse motions due to unbalanced mass. The fan rotor system commonly is composed of one rigid shaft and two flexible support structures (such as squirrel cages), which is effective to decrease the critical speeds avoiding serious shaft vibration due to unbalance. Scaled test rig for realistic fan rotor system is set up according to similarity principles, governing differential equations of which are deduced by means of Lagrangian approach with four degrees of freedom. In contrast to modeling a traditional flexible rotor system, the system stiffness is not determined by the shaft but the two flexible support structures. The rigid shaft only contributes to the inertial items of the governing equations. Parameter values of dynamic model are identified from measurements on the scaled test rig, the modal shapes and the modal energy distributions are calculated. These modal characteristics of the fan rotor system are quite different from those of a traditional flexible rotor system whose stiffness mainly contributed by its elastic shaft even the system values are consistent. The obtained modal characteristics are compared and confirmed by using the simulation results of a corresponding finite element model, in which shaft is built by rotating beam elements and its flexible structures are built by equivalent spring elements. Campbell diagrams of the fan rotor system are used to illustrate the gyroscopic effect with the increasing speeds. And then the unbalance responses are calculated through the deduced analytical formula rapidly and comparisons, including the response spectrum and orbits, the amplitude and phase frequency response curves, and operating deflection shapes, are carried out in the sub- and super-critical range.

Vibration Safety Analysis of Fan Blades

Vibration characteristics and strength analysis of two-stage variable-pitch axial-flow fan based on fluid-solid coupling method

Simulation Methodology Development for Rotating Blade Containment Analysis

Finite Element Modal Analysis and Experimental Validation of Failure Caused by Vibration of a Fan

Vibration Equation and Frequency Computation of an Aero-engine Rotor Blade

Numerical Study on Air-Structure Coupling Dynamic Characteristics of the Axial Fan Blade

Non-linear Transient Rotor-dynamics Analysis of Fan Blade Out

Blade Self-excited Vibration with Identification of Fan Using Microphone Array

Numerical Simulation and Experimental Validation of Failure Caused by Vibration of a Fan

Blade Fracture Analysis of a Motor Cooling Fan in a High-Speed Reciprocating Compressor Package

Analysis of Blade Tip Timing Data from Fan Blades with Synchronous and Non-Synchronous Vibration

Analyses of the Single Blade Strength and Calculation of the Circle Blade Dynamic Frequency

Modal characteristics and unbalance responses of fan rotor system with flexible support structures in aero-engine

High Stress Vibration Fatigue Test Technology of Aeroengine Blade

Modal Analysis of a Turbine Blade Based on Fluid-Thermal-Structural Coupling

A New Method of Analysis on Natural Frequency Correlation of Wind Turbine Blade

Investigation on the Dynamic Response of a Wide-Chord Fan Blade under Ground Vortex Ingestion

Nonlinear Stress Analysis on Blade of Tunnel Fan

Research on Blade Wind-Induced Vibration in Wind Direction

Free vibration analysis of a rotating varying-thickness-twisted blade with arbitrary boundary conditions

Dynamic response analysis of shrouded blades under impact-friction considering the influence of passive blade vibration