Abstract:Monitoring rotor blade vibrations is imperative in aero-engine testing and service. Blade tip timing (BTT), a promising technique for such monitoring, assesses the operational status of rotor blades through non-intrusive measurement of blade tip displacement. Traditional BTT technology relies on the Once-Per-Revolution (OPR) probe, which poses installation challenges and introduces measurement uncertainties in practical applications. This paper introduces a novel OPR-free approach, employing Adaptive Variable Reference Blades (AVRB) for non-intrusive measurement of rotor blade vibrations. The method assumes a stochastic mistuning of blades within the same stage, resulting in non-simultaneous resonance of blades at a given speed. In each revolution, the vibration level of individual blades is determined by assessing the deviation between the average speed of a blade, as measured by two adjacent BTT probes, and the average speed across the entire circumference. Consequently, a non-vibrating blade is adaptively identified and selected as the reference blade. The relative vibration levels among blades vary dynamically during different revolutions, influenced by mistuning features, leading to variability in the reference blades. These adaptive variable reference blades can then replace the OPR probe, aiding in the computation of vibration displacement and further parameter identification of blades. To validate the effectiveness of the proposed method, a five-degree-of-freedom numerical model is utilized for simulation. Additionally, experiments involving both a five-bladed disk and an eight-bladed disk are conducted to validate the proposed approach. Numerical simulations and two sets of test results demonstrate a fundamental agreement between the blade vibration displacement calculated using the proposed method and the outcomes obtained through the traditional BTT method with OPR. The relative error in the identified blade vibration frequency derived from the blade vibration displacement, as determined by both methods, does not exceed 1 %. Additionally, the relative error in the amplitude of the blade vibration displacement is within the range of 10 %.

Analysis of Blade Tip Timing Data from Fan Blades with Synchronous and Non-Synchronous Vibration

Research on Vibration Characteristics of Last Stage Blade Based on Blade Tip-Timing Technology

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

An Improved Blade Tip-timing Method for Vibration Measurement of Rotating Blades During Transient Operating Conditions

A blade tip-timing method without once-per-revolution sensor for blade vibration measurement in gas turbine engines

Measurement Methodology: Blade Tip Timing: A Non-Contact Blade Vibration Measurement Method

A Novel OPR-free Method for Blade Tip Timing Based on Adaptive Variable Reference Blades

Tip Timing Based Non-contact Vibration Measurement of Aero-engine Turbine Blades

Improved Non-contact Vibration Measurement Via Acceleration-based Blade Tip Timing

Phase-offset-based Synchronous Resonance Identification Method for Blade Tip Timing Signal

Blade Tip Timing for Multi-Mode Identification Based on the Blade Vibration Velocity

Synchronous vibration identification of fan blisk based on acoustic mode decomposition

A Novel Blade Vibration Monitoring Experimental System Based on Blade Tip Sensing.

Experimental Investigation on the Accuracy of Blade Tip Timing Spectral Analysis Methods

Parameter Identifications of Synchronous Vibration of Rotating Blades with Large Amplitude Based on Blade Tip Timing

Research on Detecting Technology of Rotating Blade Vibration Performance Parameters

Blade Tip Timing: from Raw Data to Parameters Identification

A Keyphasor-Free Traveling Waves Analysis Method Based on Blade Tip Timing and Experimental Validation

Single-Probe Blade Tip Timing: A Novel Method for Anomaly Identification Based on Frequency Shift.

An OPR-free Blade Tip Timing Method Based on Blade Spacing Change

An error correction blade tip-timing method to improve the measured accuracy of blade vibration displacement during unstable rotation speed