Simulation research of bubble growth behavior in oxygen bottom blowing smelting process
GUO Xue-yi,WANG Shuang,WANG Qin-meng,YAN shu-yang,TIAN Qing-hua
DOI: https://doi.org/10.19476/j.ysxb.1004.0609.2018.06.16
2018-01-01
The Chinese Journal of Nonferrous Metals
Abstract:Based on the commercial CFD software ANSYS Fluent, the VOF model was adopted to study the bubble growth behavior in the process of bottom blowing oxygen. A single bubble was simulated to study the growth and fracture behavior of in the water, and it is found that the resident time of bubble is longer with smaller diameter and deeper position. It provides theoretical guidance for the rising and deformation of bubbles in melt. Again to respectively study the cross section of single lance with the methods of two-dimensional numerical simulation. Also, the phase fraction, the bubble shape, growth frequency and diameter, including the bubble deformation, integration, and rupture process were analyzed. By the researches, the diameter of the initial bubble oxygen gun is about 400 mm in the outlet of oxygen lances, and frequency of the bubble generated is about 4 Hz. The distribution of bubble diameter conforms to the Boltzmann distribution function inside the molten bath under the steady state, bubble ranging from 0 to 100 mm accounts for about 80%. The time of bubble breakdown is shorter than that of bubble fusion, so bubble breakdown fusion is easier. Bubble breakdown can strengthen the melt mixing and enhance effect of mass transfer and heat transfer.