Abstract:The graphite floating ring is a key sealing element of the turbopump of aeroengines. Its wear induced by frequent flotation during its operation can result in stress concentration and microscopic cracks in its seal end face, more leakage from its sealing surface, a lower engine efficiency, and even serious safety concerns. However, there are currently no published studies regarding the modeling of the end face wear of the floating ring seal. This work presents a new fractal model for predicting the wear rate and wear evolution of the end face of the floating ring seal. Firstly, a new normal fractal contact model was implemented by microscopically considering the deformation mechanism, interaction forces, and flash points of the asperities on the end face of the floating ring. On this basis, a fractal model was built to predict the wear of the end face of the floating ring according to its wear mechanism and the corrected Archard theory. The wear rates predicted according to this model are in good agreement with the test results. The simulation results show that (i) the depth wear rate of the end face of the floating ring first decreases and then increases as the fractal dimension D increases (the minimum is reached when the fractal dimension ranges from 1.60 to 1.725); (ii) the depth wear rate of the end face of the floating ring increases as the characteristic scale G , friction factor f , floatation speed of the floating ring v , and end face pressure P increase; (iii) the impact of the end face pressure on the depth wear rate is minimum when the fractal dimension ranges from 1.60 to 1.65; (iv) the flotation displacement of the floating ring cannot exceed 12 μm when the engine speed is higher than 30,000 r/min.

Study on Single Fractal and Multifractal of Frictional Forces in the Running-in Process

Application of Fractal Features in Prediction of the Wet Clutch Wear-in State

A Novel and Quantitative Determination Method for the Running-in Process Through Dimensionless Real Contact Area

On the Running-in Behavior of Rough Surface of Piston Rings in Mixed Lubrication Regime

Study on the Frictional Performance of Slide and Plateau Honed Cylinder Liners During Running-in

Experimental Investigation on the Friction-Induced Vibration with Periodic Characteristics in a Running-In Process under Lubrication

Measurement and Characteristics Analysis of Frictional Contact Forces in a Pin-on-disc System

Measurement and characteristics analysis of frictional

Investigation into the Dynamical Friction Characteristics under Squeal Conditions Based on a Pin-on-disc System

Friction and Wear On-Line Monitoring and Wear Mechanism Analysis under Dynamic Loading Manners

Topography Characterization of Friction Pairs During the Real-Time Wear Process in Dry Condition

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Sliding Behaviour of Friction Material Against Cermet Coatings: Pin-on-Disc Study of the Running-in Stage

Surface Topography Characterization in Steel Running-in Process of Dry Sliding Friction

Adhesion-fatigue Dual Mode Wear Model for Fractal Surfaces in AISI 1045 Cylinder-Plane Contact Pairs

A study on building and testing fractal model for predicting end face wear of Aeroengine's floating ring seal

Study the Relationship of 3D Coating Morphology and Frictional Wear Based on Dual Surface Image

Correlation Between Friction Coefficient and Friction Vibration in Running-In Process Based on Cross Recurrence Plots

Impact Analysis of Worn Surface Morphology on Adaptive Friction Characteristics of the Slipper Pair in Hydraulic Pump

Fractal characterization of the wear particle accumulation in the wear process of copper against steel

Wear Characterization under Sliding–rolling Contact Using Friction-Induced Vibration Features