Abstract:The paper addresses the method for stator and rotor resistance identification in speed sensorless induction motor drives. The instability problem caused by pure integration of the voltage model (VM) of rotor flux is handled by introducing correction terms in the VM. It is, however, shown that the third-order persistent excitation (PE) condition for simultaneous identification of stator, rotor resistances and rotor speed can barely be satisfied even with extra excitations in rotor flux modulus command. And an adaptive observer that is not persistently excited may become instable when exposed to bounded disturbances. Hence, to design a robust flux observer, concept of time-division multiplexing is incorporated into the observer design. That is, stator resistance is identified as the flux modulus is flat, while rotor resistance is adapted as a ramp flux modulus command is applied. This relaxes PE condition to order two, and as a drawback, the ramp flux modulus command incurs speed ripples. The decoupled identifiability of stator resistance is designed and explained, a rigorous input-to-state stability analysis of both the mismatch [between VM and current model (CM)] and the error (between actual rotor flux and CM) is set forth, and a convergence analysis of parameters is elaborated. To validate the feasibility, simulation and experiment results are included in the text as well.

A Constant Gain Adaptive Observer for Speed and Resistances Identification

An Adaptive Observer Design for Sensorless Control of Induction Motors

Adaptive Sliding Mode Observer for Speed-Sensorless Control of PMSM

Speed Control For A Permanent Magnet Synchronous Motor With An Adaptive Self-Tuning Uncertainties Observer

Alternative Solution Regarding Problems of Adaptive Observer Compensating Parameters Uncertainties for Sensorless Induction Motor Drives

Totally Adaptive Observer For Speed Sensorless Induction Motor Drives: Simply A Cost Of Extra Energy Consumption

Study of Adaptive Flux Observer and Speed Identification Method for Induction Motor

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Stabilizing Method of Speed Adaptive Flux Observer for Speed Sensorless Induction Motor Drives

Second-Order Sliding-Mode Observer With Online Parameter Identification for Sensorless Induction Motor Drives

Application of Adaptive Observer to Sensorless Induction Motor Via Parameter-Dependent Transformation

Stable Simultaneous Stator and Rotor Resistances Identification for Speed Sensorless IM Drives: Review and New Results

Nonlinear Flux Observer for Sensorless Control of IPMSM Based on a Novel Regression Model

Resistances and Speed Estimation in Sensorless Induction Motor Drives Using a Model With Known Regressors.

Design Method of Adaptive Full Order Observer With or Without Estimated Flux Error in Speed Estimation Algorithm

Full-order Flux Observer Based on Speed and Stator Resistance Adaptation for Induction Motor

Robustness Improvement for Adaptive Full Order Observer in Sensorless Induction Motor Drives

Backstepping Control of Speed for Sensorless Permanent Magnet Synchronous Motor

Adaptive Speed Observer for Speed Sensorless Control of Induction Motor

Joint Estimation of Resistance and Speed with Auxiliary State of Active Flux for Sensorless IPMSM Drives

Speed convergence rate-based feedback gains design of adaptive full-order observer in sensorless induction motor drives