Abstract:Introduction. The control algorithm of Induction Motor (IM) is massively dependent on its parameters; so, any variation in these parameters (especially in rotor resistance) gives unavoidably error propagates. To avoid this problem, researches give more than solution, they have proposed Variable Structure Control (VSC), adaptive observers such as Model Reference Adaptive System, Extended Luenberger Observer (ELO) and the Extended Kalman Filter (EKF), these solutions reduce the estimated errors in flux and speed. As novelty in this paper, the model speed observer uses the estimated currents and voltages as state variables; we develop this one by an error feedback corrector. The Indirect Rotor Field Oriented Control (IRFOC) uses the correct observed value of speed; in our research, we improve the observer’s labour by using back-stepping Sliding Mode (SM) control. Purpose. To generate the pulse-width modulation inverter pulses which reduce the error due of parameters variations in very fast way. Methods. We develop for reach this goal an exploration of two different linear observers used for a high performance VSC IM drive that is robust against speed and load torque variations. Firstly, we present a three levels inverter chosen to supply the IM; we present its modelling and method of control, ending by an experiment platform to show its output signal. A block diagram of IRFOC was presented; we analyse with mathematic equations the deferent stages of modelling, showed clearly the decoupling theory and the sensorless technique of control. The study described two kinds of observers, ELO and EKF, to estimate IM speed and torque. By the next of that, we optimize the step response using the fuzzy logic, which helps the system to generate the PI controller gains. Both of the two observers are forward by SM current controller, the convergence of SM-ELO and SM-EKF structures is guaranteed by minimizing the error between actual and observed currents to zero. Results. Several results are given to show the effectiveness of proposed schemes.

Adaptive Speed Observer for Speed Sensorless Control of Induction Motor

An Adaptive Observer Design for Sensorless Control of Induction Motors

Adaptive Sliding Mode Observer for Speed-Sensorless Control of PMSM

Sensorless IPMSM Control Based on an Extended Nonlinear Observer with Rotational Inertia Adjustment and Equivalent Flux Error Compensation

Speed Control For A Permanent Magnet Synchronous Motor With An Adaptive Self-Tuning Uncertainties Observer

Speed Sensorless Vector Control Based on Full-order Adaptive Observer for Induction Motor Drives at Low Speed

Extremely Low Speed Performance Research of the Speed Sensorless Vector Controlled Induction Motor Drive System

Alternative Solution Regarding Problems of Adaptive Observer Compensating Parameters Uncertainties for Sensorless Induction Motor Drives

Low Speed Stability Research of Adaptive Full-order Observer for Induction Motor

Adaptive sliding-mode observer for speed-sensorless control of induction motors

Research on Sensorless Control Method of PMSM Based on an Adaptive Sliding Mode Observer

A Novel Sliding-mode Observer for Speed-sensorless Induction Motors

Intelligent fuzzy back-stepping observer design based induction motor robust nonlinear sensorless control

High Dynamic Sensorless Control for PMSMs Based on Decoupling Adaptive Observer

Position and Speed Sensorless Control of Brush-Less DC Motor Based on an Adaptive Observer.

Speed Sensorless Fuzzy Vector Control of Induction Motor Using an Adaptive Observer

Application of Adaptive Observer to Sensorless Induction Motor Via Parameter-Dependent Transformation

Sensorless Robust Predictive Current Control For Induction Motor Using A Speed Adaptive Full-Order Observer

Induction Motor Control Strategy Based on Full Order Adaptive Speed Observer

Design Method of Adaptive Full Order Observer With or Without Estimated Flux Error in Speed Estimation Algorithm

Adaptive Observer for Sensorless Control of Permanent Magnet Synchronous Motor Drives