Abstract:Based on heat conduction theory,a finite element method is introduced to investigate the three-dimensional transient temperature fields in a moving plate irradiated by a laser beam.The laser beam is assumed to be with Gaussian distribution,and the plate is considered as infinite along the motion direction,while the width and the height are finite.Considering the thermal physical parameters depended on temperature,convection and radiation factors of the surfaces,and the motion of the plate,the temperature fields on the upper and bottom surfaces of the plate are obtained.The numerical results show that the quasi-steady state temperature fields are approached.Comparing the temperature fields obtained by before and after considering the factors described above,it shows that the temperature dependences of the thermal properties of the material have distinct influences on the temperature fields.In the conditions that the thermal conductivity and thermal capacity of the material are dependent of temperature,the results are presented for two cases:(1) when neglecting temperature dependence of the thermal capacity,the maximum temperature and the quasi-steady state temperature are both higher than those of considering the temperature dependence;(2) when neglecting temperature dependence of the thermal conductivity,the maximum temperature will decrease while the quasi-steady state temperature will be the same as that of considering the temperature dependence.In addition,with increasing the convective heat transfer coefficient at the upper surface,the maximum temperature and the quasi-steady state temperature will decrease,while the effect of radiative heat losses of the surface can be ignored.Meanwhile,changing the moving velocity not only affects the temperature fields,but also alters the maximum temperature and the time for reaching the quasi-steady state condition.Furthermore,with the radius of the laser source decreasing,the maximum temperature and quasi-steady state temperature will both increase,while the former change is more obvious.

Integration Effects of Twice Irradiations on Homogenizing Distribution of One-Dimentional Impurity Concentration

Model Optimization of Infrared Homogenization for Inertial Confinement Fusion Cryotargets

Selected Two-Dimensional Effects in Gas Immersion Laser Doping of Unpatterned Silicon

Flatting of Temperature Distribution in Laser Induced Diffusion Region

Quantum-Well Intermixing For Optoelectronic Integration Using High-Energy Ion-Implantation

Experiments and analysis on Joule heating effect in field-assisted ion diffusion

Realization of High Irradiation Uniformity for Direct Drive ICF at the SG-III Prototype Laser Facility

The Elimination of Thermal Runaway in 10.6 μm Laser-Induced Diffusion

Controllable Design of Minority Carrier Diffusion in Npn Devices for Enhancing Er3+-Related Electroluminescence

Simulation Of The Velocity Distribution For Immersion Lithography

Effects of inhomogeneous medium on the high-intensity-laser propagation

Finite element analyses of temperature fields in moving solids irradiated by a laser source

Indium Phosphide Single Crystal Furnace Cooling Crystallization Temperature Control Model Research

A simple expression for impurity distribution after multiple diffusion processes

Studying the Suppression of Quantum Well Intermixing in Primary Epitaxial Wafers Via Oxygen Ion Bombardment

The SIMS Measurement of Zn Concentration Distribution Induced by Laser

Machine learning based laser homogenization method

Thermodynamic Processes on a Semiconductor Surface During In‐situ Multi‐beam Laser Interference Patterning

Research on target uniform irradiation method using linearly modulated light and special grating dispersion

Simulation and Experimental Research on a Beam Homogenization System of a Semiconductor Laser

Temperature Uniformity of the Laser Exposed Area