Abstract:Synchronous analysis is one of the most effective and practical techniques in rotating machinery diagnostics, especially in cases with variable speed operations. A modern analog-to-digital convertor (ADC) usually digitizes an analog signal to an equal time interval data series. Synchronous resampling converts the data series from an equal time interval data series to an equal shaft rotation angle interval data series. This conversion is usually achieved in the digital domain with the aid of shaft speed information, through either direct measurement or identification from a measured vibration signal, which is a time-consuming process. In order to improve the computational efficiency as well as the data processing accuracy, in this paper, a fast synchronous time-point calculation method based on an inverse function interpolation procedure is proposed. By identifying the inverse function of the instantaneous phase with respect to time, the calculation process of synchronous time points is optimized, which results in improved calculation efficiency and accuracy. These advantages are demonstrated by numerical simulations as well as experimental verifications. The numerical simulation results show that the proposed method can improve calculation speed by about five times. The synchronous analysis based on the proposed method was applied to a bearing fault detection in a high-speed rail carriage, which demonstrated the advantages of the proposed algorithm in improving the signal-to-noise ratio (SNR) for bearing damage feature extraction.

Research on Algorithm to Compute Rotating Speed of Rotating Machinery Based on Digital Differential and Averaging Pulses

Research on Digital Estimation Method of Motor Speed and Rotor Position

Digital Approach to Rotational Speed Measurement Using an Electrostatic Sensor

Virtual Torque and Rotational Speed Measuring Device

Amplitude Correction Approach Using Average of Several Points in Discrete Spectrum for Analyzing the Dynamic Signal of Rotating Machinery with Varying Speed

A Computer-Vision-based Rotating Speed Estimation Method for Motor Bearing Fault Diagnosis

Instantaneous Rotational Speed Measurement Using Image Correlation and Periodicity Determination Algorithms.

Bearing Fault Diagnosis under Time-Varying Speed and Load Conditions Via Speed Sensorless Algorithm and Angular Resample

Fluctuation Analysis of Instantaneous Angular Speed Based on Digital Differentiator and Its Application in Vibration Source Identification

Use of Double Correlation Techniques for the Improvement of Rotation Speed Measurement Based on Electrostatic Sensors

Research on New Software Compensation Method of Static and Quasi-Static Errors for Precision Motion Controller

Speed Condition Monitoring of Rotating Machinery Using Electrostatic Method

Research on all di gital R2 D converter for angular position diff eren ce

Rotational Speed Measurement Through Electrostatic Sensing and Correlation Signal Processing

A Motor-rotating-speed Measuring Method Based on TMS320F2812

Rotational Speed Measurement Using Electrostatic Sensors and Correlation Signal Processing Techniques.

Research on the automobile's speedometer and odometer using crossed-coil controlled by microcomputer

Research on acceleration-deceleration control algorithm based on moving average method

Improved Synchronous Sampling and Its Application in High-Speed Railway Bearing Damage Detection

Rotational Speed Measurement Through Image Similarity Evaluation and Spectral Analysis

A review and strategy for the diagnosis of speed-varying machinery