Abstract:The wear of oil pump vanes easily leads to the noise and vibration, even results the decrease of volume efficiency and total efficiency. In order to reduce the friction and improve the lubrication between the vane and the pump inner wall, the micro-machining of micro-structure on the oil pump vanes is proposed. First, the micro-V-grooves with the depth ranging from 500 mu m to 50 mu m were micro-grinding on the top of the vanes by a diamond grinding wheel. Secondly, the experiments were conducted to test the actual flow rate, the output power and the overall efficiency of the oil pump with and without the micro-groove vanes. Then, the computational fluid dynamics (CFD) method was adopted to simulate the pump internal flow field. Finally, the micro-flow field between the internal wall of the oil pump and the top of micro-grooved vanes was analyzed. The results shows that the pump overall efficiency increased as the decrease of micro-groove depth from 500 mu m to 50 mu m and not be affected by the rotate speed and working frequency of the pump rotator. Especially the micro-groove with depth of 50 mu m, the actual flow rate, the output power and the overall efficiency reached to the maximum. From CFD simulation, the velocity of the micro-flow between the surfaces of the vane and inner wall was larger than the pump linear velocity when the microstructure depth is larger than 50 mu m, leading to an internal leakage. When the micro-groove depth is between 10-50 mu m, the velocity of the micro-flow was less than the pump linear velocity and no internal leakage was found, but the oil film thickness is too small to be beneficial to lubrication according to the fluid dynamic characteristics. Thus, for the oil pump equipping with micro-grooved vane with the depth of 50 mu m, the internal leakage not only is avoided but the lubrication efficiency is improved and the oil pump efficiency is also enhanced.

Research on Working Mechanism and Performance of New Vane Secondary Component

An Effective Method for Improving the Lifetime of Double Acting Vane Pump

An Investigation in Performance of a Variable-Speed-Displacement Pump-Controlled Motor System

Research on New Type of Fast-Opening Mechanism in Steam Turbine Regulating System and Optimization of Operation Tactic

Research on Dynamic Characteristics of the Rotary Valve.

Optimization of Valve Plate Applied in Secondary Unit and Noise Reduction

Development and Research Overview on Variable Frequency Hydraulic Technology

Experiment Investigation on Secondary Flow Loss and Flow Control Mechanisms in a Variable Compressor Cascade with Penny Cavities

Lubrication and Fluid Film Study on the Vane Tip in a Vane Pump Hydraulic Transmission Considering a Fluid and Structure Interaction

The Mechanism Performance of Improved Oil Pump with Micro-Structured Vanes

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Studies on Several Key Problems of Water Hydraulic Vane Pump

Design and Characteristic Research on Variable Displacement Mechanism of Two-Dimensional (2D) Bivariable Pump

Secondary flow and loss mechanisms of variable stator vanes in an annular cascade

Design and Dynamic Analysis of a Novel Double-Swing Vane Compressor for Electric Vehicle Air Conditioning Systems

Hydraulic Characteristics Study of Variable Clearance Semi-high Guide Vane Centrifugal Pump

Investigation on the characteristics of a high-frequency two-dimensional rotary valve generating fluid pulse width modulation wave

A Study On Velocity Modulated Performance Of Secondary Regulated System With Constant Load

Analysis of vane loads and motion in a hydraulic double vane pump with integrated electrical drive

Dynamic Characteristics of Double-Decked Vane Mechanism

A Theoretical Study on the Novel Structure of Vane Compressor for High Efficiency