Abstract:The multistage process of cold stamping of a thin-walled steel vessel is assessed taking into account the technological heredity. The quality of the product is related with the residual resource of plasticity, i.e., with the remoteness of its deformed state from the ultimate strain curve. The process is calculated using a model of large plastic strains of an anisotropic shell, considering the dynamics and contact interaction with the tool, which is numerically implemented in the LS-DYNA® package. The numerical simulation was performed using the law of plastic flow of an anisotropic sheet, associated with the Barlat Yld 2000-2d yield function with power-law isotropic strain hardening, the Peng–Landel potential of the nonlinear elastic behavior of a polyurethane die, and the Coulomb friction law for describing the contact interaction of a product with a tool. The material constants of low-carbon 0.7-mm-thick sheet steel DC04EK and polyurethane SKU-PFL were determined earlier from experimental data. The forming limit curve is constructed from the distortion of the coordinate grid near the zones of localization of deformation and destruction of the vessel in the technological process, from which intermediate annealing is excluded, and from the results of the fracture test under uniaxial tension. The features of the strain paths at the control points of the lateral surface of the product are analyzed at each stage of the technological process, which consists of a sequence of drawing, expanding, and necking operations. The calculated strain paths were verified by the experiment in which the press equipment used as the test facility. It was found that the operation of expanding the workpiece after its drawing quickly brings the material to the ultimate state and requires preliminary recovery of the plasticity resource by annealing. The prospects of stamping technologies with lower expansion ratios and higher necking ratios, capable of maintaining the plasticity resource without intermediate annealing, are noted.

Application of Numerical Simulation to Stamping Process for Motorcycle Tank Shell

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Parameters Optimization of Tailor Welded Blank Forming Process

Numerical Simulation of Positive Installing Style Toggle-Drawing Forming for the Covering Part of the Fuel Tank Shell

Thermo-mechanical coupled simulation of hot stamping components for process design

Prediction and Simulation of Elliptical Drawing Based on DYNAFORM

Numerical Simulation and Process Improvement of a Typical Car Thread Plate

Digital Twin-Driven Sheet Metal Forming: Modeling and Application for Stamping Considering Mold Wear

Application and development of algorithm for sheet hydro-forming in numerical simulation

Numerical Simulation of Hot Stamping Forming of AZ Series Magnesium Alloys and Optimization of Die Process

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Numerical Simulation of Microstamping Process to Fabricate Multi-channel of SUS304 Thin Sheets with Consideration of Grain Structures

Numerical modeling of the thermal deformation during stamping process of an automotive body part

Ultimate Strength Evaluation of the Multistage Technological Process of Cold Sheet Stamping Technique for Manufacture of Thin-Walled Vessels

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

SIMULATION OF MULTI-STAGE COLD FORMING OF A THIN-WALLED VESSEL

Modeling and simulation of the flow drill screw process of a DP590/Al6061-T6 multi-material joint used for vehicle body

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

Numerical Simulation And Experimental Method For Auto-Panel Forming Defects Analysis

Study and Application of Cae Simulation in Die-Casting Die Design