Abstract:Metal gratings with rhombus holes are widely applied in lightweight aircraft components. Electrochemical machining (ECM) is a nontraditional processing technology with no tool loss and no thermal deformation that has unique advantages for the high-quality processing of rhombus holes. However, the flow paths of the electrolyte in the lateral gap are quite different, and stray corrosion easily occurs on the sidewall due to the different diagonal lengths of a rhombus hole. In this paper, a method was proposed to improve the flow field and processing localization by the synchronization of the pulse power supply and low-frequency oscillations. The on and off positions of the pulse power supply are symmetrical with respect to the wave trough of the oscillation waveform. Based on the coupled simulation of the gas-liquid two-phase flow field and electric field, the effects of assisting oscillations and synchronization of the pulses and oscillations on the void fraction, electrical conductivity, current density, dissolution rate and evolution of the anode profile were investigated. Moreover, the effects of assisting oscillations and synchronization of the pulses and oscillations on the lateral gap, sidewall slope, machining fillet and surface quality were experimentally studied. The experimental results of different ECM methods showed that the coupled simulation was effective and feasible. Moreover, the simulation analysis and experimental results both revealed that the processing accuracy and surface quality of a rhombus hole could be improved by using the synchronized ECM method. The lateral gap at the rhombus hole entrance was only 0.13 mm, the sidewall slope was 0.026 and the surface roughness was Ra0.134 μm under the optimized parameters.

High Frequency Group Pulse Electrochemical Machining of Ultrathin Structural Parts

Development of HSPECM Set-Up and Its Experiments

Electrochemical machining of a rhombus hole with synchronization of pulse current and low-frequency oscillations

Pulsed Micro-Electrochemical Machining Technology

Fabrication of Micro Structures by Ultra Short Voltage Pulse Electrochemical Machining

ELECTROLYTIC MICROMACHINTNG WITH HIGH FREQUENCY SHORT PULSE CURRENT

Electrochemical Machining for Micro Holes with High Aspect Ratio on Metal Alloys Using Three-Electrode PPS in Neutral Salt Solution

Pulse electrochemical meso/micro/nano ultraprecision machining technology

Research on the High Frequency Pulse Generator of Electrochemical Machining Based on CPLD

The Tool Design and Experiments on Pulse Electrochemical Machining of Micro Channel Arrays on Metallic Bipolar Plate Using Multifunctional Cathode

Electrochemical Micromachining Based on Multifunction Machine Tool

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

Electrochemical Micro Machining of Stainless Steel with Voltage Pulses

High-speed Electrochemical Discharge Drilling (HSECDD) for Micro-Holes on C17200 Beryllium Copper Alloy in Deionized Water

Electrochemical Machining of Micro Slots Using Shaped Electrode

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Study On Micro Electrochemical Machining At Micro To Meso-Scale

Wire Electrochemical Machining with Pulsating Radial Electrolyte Supply and Preparation of Its Tube Electrode with Micro-Holes

Performance improvement of high-speed EDM and ECM combined process by using a helical tube electrode with matched internal and external flushing

Surface-improvement mechanism of hybrid electrochemical discharge process using variable-amplitude pulses