Abstract:The use of recycled brick aggregates (RBAs) in concrete could provide sustainable solution in construction industry by reducing the consumption of natural resources and protecting the environment by saving landfill sites. However, the use of RBAs is uncommon due to limited available research studies investigating its mechanical and durability behavior, especially the freeze-thaw (FT) behavior. Despite a few studies on FT resistance of RBA concrete (RBAC), the FT deterioration mechanism in RBAC is not fully understood, particularly at the microscale. This lack of understanding hinders the widespread adoption of RBAC in sustainable construction practices, particularly in cold regions. Therefore, this study investigates the FT deterioration mechanism in RBAC using macro and microscale experiments and proposes a Weibull damage model to accurately describe the damage variation in RBAC. RBAC specimens with different water-cement (w/c) ratios of 0.65, 0.5 and 0.35 and RBA replacement levels of 0%, 25%, 50% and 100% were produced and tested under rapid FT cycles. Surface scaling, mass loss, relative dynamic modulus of elasticity, and compressive strength reduction were evaluated. X-ray computed tomography (XCT) was used to characterize pore structure and microcracking alterations during FT cycles. The results showed that the deterioration of RBAC increased with the increase in RBA replacement level. XCT revealed increased porosity and microcracking within the RBA particles, which was linked to the significant damage observed in RBAC compared to reference concrete. Quantitative analysis of pore size distribution before and after FT cycling revealed a substantial increase in small pores (<1 mm3) in RBAC. The proposed Weibull distribution damage model accurately described the damage variation in RBAC with different w/c ratios. This study provides new insights into multiscale FT deterioration mechanisms affecting RBAC, aiding in optimizing RBAC mix designs to balance sustainability and durability.

Freeze-thaw durability estimation of concrete tower for flood discharge at Bajiazui reservoir

Development of Internal Moisture Transfer and Cumulative Residual Strain in Concrete under Freeze-Thaw Cycles

Characterizations and Quantification of Freeze-Thaw Behaviors of Recycled Brick Aggregate Concrete

Environmental Factors Influencing The Durability Of Concrete Structures In Frost Environments

Frost Resistance of Concrete for Arch Dam of Jinping Hydropower Station I

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Numerical Simulation of the Effect of Freeze–Thaw Cycles on the Durability of Concrete in a Salt Frost Environment

Mesoscale Simulation of Fatigue Behavior of Concrete Materials Damaged by Freeze-Thaw Cycles

Flexural Behaviour of Reinforced Concrete Beams under Freeze–thaw Cycles and Sustained Load

A stochastic damage model for evaluating the internal deterioration of concrete due to freeze–thaw action

Study on the freeze-thaw effect on concrete arch dam using an improved response surface method

Experimental Study and Mechanism Analysis on Frost Resistance of Normal Performance Concrete under Different Environments

Flexural behaviour of reinforced concrete members subjected to freeze-thaw cycles

A Numerical Study on Chloride Diffusion in Freeze-Thaw Affected Concrete

Experimental Study on Mechanical Properties and Pore Structure Deterioration of Concrete under Freeze–Thaw Cycles

The Influence of Freeze–Thaw Cycles and Corrosion on Reinforced Concrete and the Relationship between the Evolutions of the Microstructure and Mechanical Properties

Evaluation of fracture behavior of high-strength hydraulic concrete damaged by freeze-thaw cycle test

Investigation of Opening and Closing Water Boundary Conditions on Frost Damage Development in Concrete

The durability of concrete subject to mechanical load coupled with freeze–thaw cycles: a review

Study on Freezing-Thawing damage mechanism and evolution model of concrete

Study on pore structure and the mechanical properties of sandstone-concrete binary under freeze-thaw environment