Abstract:The helium circulator is the key equipment to drive the helium gas flowing in the primary loop for energy exchange in HTGR. Active magnetic bearings (AMB) have been considered as an alternative to replace traditional mechanical bearings in the helium circulator. Such contactless bearings do not have frictional wear and can be used to suppress vibration in rotor-dynamic applications. It is necessary to study the vibration characteristics of the maglev helium circulator to guarantee the reactor safety. Therefore, a maglev circulator test rig was built. The power of the circulator is 180 kW and the maximum speed is 17000 rpm. For the time being, the test atmosphere is air. In this paper the test rig was introduced. Vibration test work of the maglev circulator was also carried out. The measuring points were arranged at the seat because the seat vibration level is important to evaluate the machine noise. The measuring points were also arranged at the base of the circulator housing to better study the vibration characteristics. The vibrations were measured by the LC-8024 multichannel machinery diagnoses system. At each measuring point the vibrations were detected in three directions(X, Y and Z) with the vibration acceleration sensors. The test speeds varied from 1000 rpm to 17000 rpm with an increase of 1000 rpm each time. The vibration values of the seat are from 89.5 dB at 1000 rpm to 113.3 dB at 17000 rpm. The test results showed that the maglev circulator exhibits good vibration properties. This work will offer important theoretical base and engineering experience to explore the high-speed helium circulator in HTGR.

Magnetically Suspended Rocket Motor Thrust Test Stand

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Thrust Characteristic Analysis and Test of the Synchronous Permanent Magnet Linear Motor

Unconstrained measurement method and verification of thrust vector in small solid propulsion system

ANALYTICAL MODELING AND PARAMETER EXTRACTION OF THE MAGNETIC LEVITATION FORCE FOR AN INSET PERMANENT MAGNET TYPE BEARINGLESS MOTOR

Experimental Study of a Low-Thrust Measurement System for Thruster Ground Tests

Thrust and Thermal Characteristics of Electromagnetic Launcher Based on Permanent Magnet Linear Synchronous Motors

Analysis of magnetic field and levitation force of single magnet

Axial Active-Passive Suspension Electromagnetic System in Radial Air Gap for the Maglev Pump.

The Thrust Characteristics Investigation of Double-Side Plate Permanent Magnet Linear Synchronous Motor for EML

Lubrication and Stability Enhancement by Attaching Superconducting Magnetic Force on Non-Contacting Mechanical Seals for Reusable Rocket Turbopump

Levitation Force of Small Clearance Superconductor–magnet System under Non-Coaxial Condition

An Electromagnetic Launcher with Magnetic Levitation Realized Based on Vector Control

Full elastic microthrust measurement equipment

Electromagnetic Levitation Micromotor with Stator Embedded (ELMSE): Levitation and Lateral Stability Characteristics Analysis

One Electromagnetic Launcher Based on Vector Control

Numerical and experimental investigations on the influence factors of diamagnetic levitated electrostatic motor

Fundamental Tribological Experiments and Antifriction Design of Novel Superconducting Tilting Pad Bearing for Liquid Rocket Engine

Analysis and Design of Moving-Magnet-Type Linear Synchronous Motor for Electromagnetic Launch System

ICONE23-1786 VIBRATION FEATURES OF AN 180KW MAGLEV CIRCULATOR TEST RIG

Development of a cantilever beam thrust stand for electric propulsion thrusters