Abstract:The burgeoning demand for enhanced power-system safety means that there is increased attention on technologies for the detection and location of cable faults. The double-terminal fault location method, which senses a fault current using a current transformer (CT), is the most effective and widely applied method in industrial practice. However, CT sensors may suffer from magnetic saturation when exposed to a high fault current, resulting in significant location errors, and their sensitivity cannot be adjusted. To address this problem, this paper describes an improved method for the acquisition of fault signal and the identification of fault-wave arrival time in power cables. First, a novel noncontact sensor (NCS) is developed for the detection of electric fields, and its sensitivity-adjustment curves are obtained by theoretical calculation and simulation. Then, based on feedback variational mode decomposition (FVMD) and the Wigner–Ville distribution (WVD), an improved method (the FVMD + WVD method) for the identification of fault-wave arrival time is devised, and its efficacy and accuracy are verified by simulations in Power Systems Computer-Aided Design/Electromagnetic Transients including DC (PSCAD/EMTDC) software. Finally, the fault-wave arrival-time detection performance of the NCS is examined in a series of on-site DC and AC experiments based on damped AC technology. The results show that the NCS exhibits feasible and effective performance, and that its response can be appropriately tuned based on its sensitivity-adjustment curves. The FVMD + WVD method is more accurate than several other current methods, as its error is only 0.48%, and thus this method enables the practical location of cable faults. In sum, these findings demonstrate that the NCS and the FVMD + WVD method comprise an improved system for the detection and location of cable faults, which will enhance c-ble safety in power systems.

Design of a Wireless Node Applied to Fault Location for Railway Automatic Blocking and Continuous Power Line

Detecting Faulty Nodes with Data Errors for Wireless Sensor Networks

A Robust Design of Fault Nodes Identification and Recovery Model Over Wireless Sensor Network

Implementation of Transmission Line Fault Detection System using Long Range Wireless Sensor Networks

The Implementation of a Dispatch Line Fault Location Algorithm Based on the Signal by Fault Passage Indicator

A Novel Fault Location Algorithm For Mixed Overhead-Cable Transmission System Using Unsynchronized Current Data

Method and Simulation Analysis of Comprehensively Distributed Fault Location of Transmission Line

Fault Location Method in Power Network by Applying Accurate Information of Arrival Time Differences of Modal Traveling Waves

Application of Wireless Communication in Faulty Insulator Detecting for Transmission Lines

Study on Fault Location for High Voltage Overhead Transmission Lines Based on Neural Network System

A novel traveling wave fault location method for transmission network based on time linear dependence

Design of fault location algorithm based on online distributed travelling wave for HV power cable

Distributed Traveling-Wave-Based Fault-Location Algorithm Embedded in Multiterminal Transmission Lines

The Development of Distributed Transmission Line Fault Location Device

The Design of CT Energy Harvesting Power Supply Based on Phase-Controlled Method

IF: Isolating Fault Nodes with Mobile Scanner

Fault Location Method for Transmission Line Based on Distributed Traveling Wave Detection

Fault Location in Overhead Transmission Line: A Novel Non-Contact Measurement Approach for Traveling Wave-Based Scheme

A Novel Fault Location Algorithm in Distribution Network Based on Power-on Signal and Power-off Signal

A non-contact current traveling wave fault location method for multi-terminal overhead power lines based on adaptive mathematical morphology

A Double-Terminal Traveling-Wave-Based Method Using Novel Noncontact Sensors for Fault Location in Transmission Cable Lines