Abstract:Ultrahigh-frequency (UHF) antenna sensors are used extensively for partial discharge (PD) detection to diagnose insulation systems subjected to high dV/dt voltage waveforms, e.g., inverter-fed motors. Through frequency spectrum analysis and appropriate high-pass filtering, it is possible to remove the voltage source interference and reliably detect PD activity; however, it is still unclear whether the frequency content of the signals gathered is representative of the PD or of the sample under test, acting as a transmitting antenna. In this paper, a high-frequency electromagnetic simulation software is used to estimate the emission features of turn-to-turn insulation sample models. The radiation characteristics of samples with different lengths and types are analyzed and compared with experimental data. The results show that with an increase in the length of the insulation model, both the simulated resonant frequency and the frequency spectrum of the PD signal shift to lower frequencies. The influence of the change in the angle of the insulating sample on the frequency spectrum of the PD was negligible. It can be concluded that the radiation performance of the insulating sample as a transmitting antenna affects the PD time-frequency spectrum distribution characteristics released by the test sample. In a hairpin motor stator, the lowest peak of the PD spectrum is predicted correctly by the simulated S11 response of the winding. The structural parameters of the equipment under test determine the radiation characteristics. The results can provide a basis for the frequency-domain analysis of PD, which is conducive to the extraction of characteristic parameters of PD signals and will improve the identification accuracy of PD defect types.

Measurement and Analysis of Partial Discharge under High Voltage Continuous Impulses for Inverter-fed Insulation

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

Measurement and Simulation of Partial Discharge in Oil-Paper Insulation under the Combined AC–DC Voltage

Detection and Identification Technologies of Wide Band Partial Discharge

Characteristics and Identification of Partial Discharge for Insulation Structures in High Voltage IGBT Modules Under Positive Square Wave Voltage

Impact of impulse voltage frequency on the partial discharge characteristic of electric vehicles motor insulation

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage

PD Electromagnetic Emission of Turn-to-turn Insulation in Inverter-fed Motor

An Advanced Method for Detection of Partial Discharge in Oil-Paper Insulated Transformer Bushings and Current Transformers

Study on pulse current of typical PD models in power transformer

Development and Application of DC Partial Discharge Test System

Feature Extraction And Comprehension Of Partial Discharge Characteristics In Transformer Oil From Rated Ac Frequency To Very Low Frequency

Partial discharge detection on power equipment using a magneto-resistive sensor

Partial Discharge Detection of Insultors in GIS: Effectiveness and Limitation

Partial discharge theory and technologies related to medium-voltage electrical equipment

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Partial Discharge Diagnosis for Transformer - One Step Toward Strong Smart Grid in China

TYPICAL PULSE SHAPE AND FREQUENCY CHARACTERISTIC OF THE PD SIGNAL IN OIL-PAPER INSULATION

Diagnosis of Insulation Condition of MV Switchgears by Application of Different Partial Discharge Measuring Methods and Sensors

Review of Partial Discharge Activity Considering Very-Low Frequency and Damped Applied Voltage