Abstract:We design an optical fiber spectrometer based on optical fiber Mach-Zehnder interferometer. In optical fiber Fourier transform spectrometer spectra information is obtained by Fourier transform of interferogram, which recording intensity change vs. optical path difference. Optical path difference is generated by stretching one fiber arm which wound around fiber stretch drive by high power supply. Information from detector is linear with time rather than with optical path difference. In order to obtain high accuracy wavenumber, reference beam is used to control the optical path difference. Optical path difference is measured by reference laser interference fringe. Interferogram vs. optical path difference is resampled by Brault algorithm with information from reference beam and test beam. In the same condition, one-sided interferogram has higher resolution than that of two-sided interferogram. For one-sided interferogram, zero path difference position must be determined as accurately as possible, small shift will result in phase error. For practical experiment in laboratory, position shift is inevitable, so phase error correction must be considered. Zero order fringe is determined by curve fitting. Spectrum of light source is obtained from one-sided interferogram by Fourier cosine transform. A spectral resolution of about similar to 3.1cm(-1). is achieved. In practice, higher resolution is needed. This compact equipment will be used in emission spectra and absorption spectra, especially in infrared region.

Optical-fiber fourier transform spectrometer

[Optical-Fiber Fourier Transform Spectrometer].

Optical Fiber Interferometric Spectrometer

[Research on Key Technologies of All Fiber Optic Fourier Transform Spectrometer].

Optical fiber interferometer for fourier transform spectral analysis

An Optical Fourier Transform Spectrometer Based on the Michelson Interferometer with Angle Difference Between Two Mirrors

Miniature Fourier Transform Spectrometer Based on a Fiber-Tip Interferometer.

High-Speed Fiber-Optic Spectrometer for Signal Demodulation of Inteferometric Fiber-Optic Sensors

Design of Spectrum Measurement System Based Onmach-Zehnder Optical Fiber Interference

Fiber-optic Sensing Interrogation Based on a Dual-Passband Microwave Filter for Simultaneous Measurement of Temperature and Transversal Loading.

Miniature Spectrometer Based on a Fourier Transform Spectrometer Chip and a Commercial Photodetector Array

Fiber Interferometer Spectrum Recognition Strategy for Sensitivity Enhancement and Wide-Range Wavelength Measurements

Micro assembled fourier transform spectrometer

A High-Quality Mach-Zehnder Interferometer Fiber Sensor by Femtosecond Laser One-Step Processing

Investigation and simulation of a novel spatially modulated micro-fourier transform spectrometer

Analysis of a high-speed fiber-optic spectrometer for fiber-optic sensor signal processing.

Fiber-Optic Sensing Interrogation System for Simultaneous Measurement of Temperature and Transversal Loading Based on a Single-Passband RF Filter

Experimental Results from a Thermally Tuned Silicon Photonics-Based Fourier Transform Spectrometer (Si-Fts)

Multimode optical fiber based spectrometers

All-fiber Multipath Mach⬜Zehnder Interferometer Based on a Four-Core Fiber for Sensing Applications

In-Fiber Mach–Zehnder Interferometer Based on Up-Taper Fiber Structure with Er3+ Doped Fiber Ring Laser