Abstract:This study evaluates the effects of subcritical hydrothermal treatment on palm oil mill effluent (POME) and its concomitant formations of solid hydrochar, liquid product and gaseous product. The reactions were carried out at temperatures ranged 493 K-533 K for 2 h. The highest reduction of chemical oxygen demand (COD) and biochemical oxygen demand (BOD) were 58.8% and 62.5%, respectively, at 533 K. In addition, the removal of total suspended solids (TSS) achieved up to 99%, with the pH of POME reaching 6 from the initial pH 4. The gas chromatography coupled with mass spectroscopy (GC-MS) analysis showed that the fresh POME contained n-Hexadecanoic acid as the dominant component, which gradually reduced in the liquid product in the reaction with increased temperature, in addition to the attenuation of carboxyl compounds and elevation of phenolic components. The gaseous products contained CO2, CO, H2, and C3 - C6 hydrocarbons. Traces of CH4 were only found at 533 K. CO2 is the dominant species, where the highest of 3.99 vol% per 500 mL working volume of POME recorded at 533 K. The solid hydrochars showed negligible morphological changes across the reaction temperature. The O/C atomic ratio of the hydrochar range from 0.157 to 0.379, while the H/C atomic ratio was in the range from 0.930 to 1.506. With the increase of treatment temperature, the higher heating value (HHV) of the hydrochar improved from 24.624 to 27.513 MJ kg-1. The characteristics of hydrochar make it a fuel source with immense potential. POME decomposed into water-soluble compounds, followed by deoxygenation (dehydration and decarboxylation) in producing hydrochar with lower oxygen content and higher aromatic compounds in the liquid product. Little gaseous hydrocarbons were produced due to subcritical hydrothermal gasification at low temperature.

Palm oil wastes to biofuel - Effect of temperature and gasifying agent on gas product distribution

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

Characterization of bio-oil and biochar from slow pyrolysis of oil palm plantation and palm oil mill wastes

Comparative analysis of N2 and H2 atmospheres in fast pyrolysis of mixed palm waste: Optimizing deoxygenation and hydrocarbon yield

Conversion of oil palm waste into value-added products through pyrolysis: a sensitivity and techno-economic investigation

Progress in the torrefaction technology for upgrading oil palm wastes to energy-dense biochar: A review

Pyrolysis of waste oils for the production of biofuels: A critical review

An evaluation of subcritical hydrothermal treatment of end-of-pipe palm oil mill effluent

Investigation of gauze and medical bottle co-pyrolysis on the product formation, reactivity, and reaction pathway of char, liquid oil, and gas

Comparison of the Thermal Degradation Behaviors and Kinetics of Palm Oil Waste under Nitrogen and Air Atmosphere in TGA-FTIR with a Complementary Use of Model-Free and Model-Fitting Approaches

Gasification of Liquid Hydrocarbon Waste by the Ultra-Superheated Mixture of Steam and Carbon Dioxide: A Thermodynamic Study

Influence of Co-Pyrolysis of Waste Tetra Pak with Waste Motor Oil on Product Distribution and Properties for Fuel Application

Physicochemical characterisation and kinetic modelling of wet torrefied oil palm trunk in pyrolysis condition

Auxiliary Effect of CO2 on Pyrolysis of Oily Sludge.

Thermal analysis technology to utilize waste biomass and waste heat to produce high-quality combustible gas through simulations and experiments

Production of syngas from oil palm shell biomass using microwave gasification

Characteristics, kinetics, infrared analysis and process optimization of co-pyrolysis of waste tires and oily sludge

A Route for Bioenergy in the Sahara Region: Date Palm Waste Valorization through Updraft Gasification

Current Status of the Pyrolysis and Gasification Mechanism of Biomass

Thermal Properties of Biochars Derived from Waste Biomass Generated by Agricultural and Forestry Sectors

Experimental Investigation of Biomass Waste, (Rice Straw, Cotton Stalk, and Pine Sawdust), Pyrolysis Characteristics