Measurements Of Gas Hydrate Composition And Its Thermal Conductivity

Dz Huang,Ss Fan,Dq Liang,Zp Feng
DOI: https://doi.org/10.3321/j.issn:0001-5733.2005.05.021
2005-01-01
Abstract:An experiment apparatus has been constructed to measure thermal conductivity of composite gas hydrate and gas hydrate-sand mixtures. The composite gas hydrate formed from the combination of gas (methane 90.01 volume %, ethane 5.03 volume % and propane 4.96 volume %) and 0.971 mol/m(3) aqueous sodium dodecyl sulfate (SDS) solution has a thermal conductivity around 0.55 W/(m (.) K) from - 10 degrees C to 5 degrees C and at 6.6MPa. The hydrate's thermal conductivity dependent on temperature shows glass like, grows with increasing temperature. However, the measured 1.2 W/(m (.) K) effective thermal conductivity (ETC) of the composite gas hydrate-bearing sand is significantly lower than that of tetrahydrofuran (THF) hydrate-bearing sand ( about 1.9W/(m (.) K)). This is because the hydrate formed with a SDS solution in sand at our laboratory has a "wall creeping" growth characteristic and consequently a large part of the pores were filled with free gas. In order to obtain well-characteristic hydrate samples for measurement, this work uses a method to promote the reaction of SDS solution and gas. When the temperature changes in the range from - 10 degrees C to 4 degrees C, it is found that the stagnated reaction reacts again in the zone of phase change temperature of water. And the surviving water could be consumed out after several vibration periods. The SDS' s effects on the measurement are also discussed based on experiments. We think that the SDS concentration used in this work has a minor effect on the hydrate's thermal conductivity, and it only causes a deviation of +/- 1.5%.
What problem does this paper attempt to address?