Gas Hydrate Formation and Its Thermal Conductivity Measurement

duzi huang,shuanshi fan,deqing liang,ziping feng
DOI: https://doi.org/10.1002/cjg2.765
2005-01-01
Chinese Journal of Geophysics
Abstract:An experiment has been constructed to measure thermal conductivity of combination gas hydrate and combination gas hydrate-sand mixtures. The combination gas hydrate formed from the combination gas (methane 90.01 volume %, ethane 5.03 volume % and propane 4.96 volume %) and 0.971 mol/m3 aqueous sodium dodecyl sulfate (SDS) solution has a thermal conductivity around 0.55 W/(m·K) from –10°C to 5°C at 6.6MPa. The hydrate's thermal conductivity shows glass-like dependence on temperature, i.e. it has a positive slope with temperature. However, the measured 1.2 W/(m·K) effective thermal conductivity (ETC) of combination gas hydrate-bearing sand is significantly lower than that of tetrahydrofuran (THF) hydrate-bearing sand (about 1.9 W/(m·K). This is because the hydrate formed with a SDS solution in sand at our laboratory has a “wall creeping” growth characteristic and consequently a large part of the pores were filled with free gas. In order to obtain good-characteristic hydrate sample for measurement, this work advances a method to promote the reaction of SDS solution and gas. When the temperature vibrates from –10°C to 4°C, it is found the stagnated reaction reacts again in the zone of phase change temperature of water. And the surviving water could be consumed away after several vibration periods. The SDS's effects to the measurement are also discussed by experiments. It's indicated that the SDS concentration used in this work has a minor effect to the hydrate's thermal conductivity, and it only causes a deviation of ±1.5%.
What problem does this paper attempt to address?