Abstract:A comprehensive three-dimensional model of droplet-gas two-phase flow is presented to examine the evolution of spray along the downstream of the exit orifice in an effervescent atomizer. For gas phase, the Navier-Stokes equations with k-epsilon turbulence model are solved, considering two-way coupling of the interaction between droplets and the gas phase. The dispersed droplet phase is modeled as Lagrangian entities, accounting for the physical phenomena of droplet generation from primary and secondary breakup, droplet collision and coalescence, droplet momentum, and heat transfer. This model is used to calculate the mean size and statistical distributions of atomized droplets under various operating conditions such as air-to-liquid ratio (ALR), injection pressure, liquid flow rate, nozzle exit diameter, and liquid material. The simulation results compare well with the experimental data, with an accuracy of 5% for the atomizer operated under annular flow conditions. Gas flow and spray evolution of the droplets are predicted; effects of operating conditions on the droplet mean size and distributions are discussed. Results show that ALR is one of the most important control parameters. Increasing ALR will decrease the droplet size gradually and finally tend to a certain limitation. A decreasing nozzle exit favors primary breakup, while high injection pressure has more influence on the secondary atomization. An increasing liquid mass flow rate has better primary breakup and worse overall atomization downstream. The liquid properties also have great impact on the droplet atomization. The less the viscosity and surface tension, the easier liquid breaks into smaller drops.

Droplet size of two-fluid airblast atomizer with large water/air mass flux ratio

Modeling Atomization of a Round Water Jet by a High-Speed Annular Air Jet Based on the Self-Similarity of Droplet Breakup

Effect of liquid jet diameter on performance of coaxial two-fluid airblast atomizers

Characteristics of Droplet Size Distribution Downstream of Coaxial Twin-Fluid Atomizer

Prediction of Droplet Size Distribution in Sprays of Prefilming Air-Blast Atomizers

Airblast Atomization Of The Twin-Fluid Atomizer

Atomization Process of Viscous Fluid Via Airblast Three-Channel Nozzle

A Fitting Formula for Predicting Droplet Mean Diameter for Various Liquid in Effervescent Atomization Spray

Three-Dimensional Simulation Of Effervescent Atomization Spray

Atomization Model Based on the Ligament-Mediated Spray Mechanism for Coaxial Two-Fluid Air-Blast Nozzle

Influence of atomizer exit area ratio on the breakup morphology of coaxial air and round water jets

Theoretical Atomization Model of Liquid Sheet Generated by Coaxial Swirl Injectors

Experimental Investigation on Atomization of an Air-Blast Atomizer with Plain-Orifice Nozzle and Dual-Swirl Cup

Theoretical study on atomizing model for target spray nozzle

Theoretical atomization model of a coaxial gas–liquid jet

Experiment investigation on atomization characteristic of an air-blast atomizer with centrifugal nozzle and co-dual-swirl cup

Design and Evaluation of a Laval-type Supersonic Atomizer for Low-Pressure Gas Atomization of Molten Metals

The Influence of Air and Liquid Properties on Airblast Atomization

Atomization and droplet dynamics of a gas-liquid two-phase jet under different mass loading ratios

Numerical Study on Fan-Shaped Air-Blast Atomizer Parameters

Experimental Investigation of Surface Acoustic Wave Atomization