Abstract:The reuse of the excavated soil for subgrade construction, as an alternative to the traditional excavated soil management approach, has demonstrated great potential for engineering application. However, its application is currently hindered by the poor engineering properties of soft soils and the pretreatment process. In this paper, an improved technique employing aggregation and dehydration for rapid stabilization of excavated soft clay was proposed. By wet mixing with stabilizers, excavated soft clay was transformed into separated aggregates with the larger surface areas exposed to air. During turning preservation, aggregates were further stabilized and dehydrated as a result of the combined hydration and enhanced evaporation effect. The performance of the produced stabilized-soil aggregates was explored by performing a series of laboratory tests and it was demonstrated that by enhancing the evaporation effect, moisture content of excavated soft clay decreased by over 20 % in 4 days. Through the aggregation effect, the soft clay tended to be silty in the plasticity chart and experienced an increase in optimal moisture content and a decrease in maximum dry density. Unconfined compressive strength and Californian bearing ratio tests showed that compacted aggregates exhibited reliable strength and water stability because of the enhanced cementitious and pozzolanic reactivity, which was capable for various sections of the subgrade with different classifications. Meanwhile, the performance of compacted aggregates was found to be dominated by the stabilizer content and the characteristics of the raw soil, which indicates that it would be preferred to distinguish the stabilizer dosage and the excavated soft clay to counter different requirements for engineering application. And a draft, dry and thermostatic environment for turning preservation is highly recommended for the purpose of improving the efficiency of excavated soil management.

Experimental study on transforming dredged silt from water systems into roadbase filling

Experimental study on treating the silty foundation of sea dike in Wenzhou Peninsula construction project

Stabilization of Dredged Silt from West Lake

Study Of Strength Characteristics Of Stabilized Soil By Using Stabilizing Agent Gx08 Treating Marine And Lacustrine Soft Soil In Hangzhou

In-situ Experiment on Urban Road Subgrade Improved by Plain Concrete Pile and Mixed-in-place Pile

Aggregation and Dehydration of Excavated Soft Clay and Use for Subgrade Engineering–part 1: A Laboratory Study

Aggregation and Dehydration of Excavated Soft Clay and Use for Subgrade Engineering-Part 2: A Pilot-Scale Study

Test Study on Composite Road Foundation of Soft Soil Consolidated with Mortar Sprayed Piles

Optimization of Formula for Stabilizing Muddy Soil Using Response Surface Methodology

Effect of Stabilization/solidification on Mechanical and Phase Characteristics of Organic River Silt by a Stabilizer

Experimental research on stabilized dredged silt used as embankment filling materials

Mechanical and microstructural properties of silt roadbed filling improved with cement, red mud and desulfurization gypsum

Experimental study on stabilization of humus-containing soft soil

Experimental Investigation into the Shakedown State of Unsaturated Road Base Aggregate at Various Fine Contents and Matric Suctions

Combination of Vacuum Preloading and Lime Treatment for Improvement of Dredged Fill

Combined stabilization/solidification and electroosmosis treatments for dredged marine silt

Analysis of the Synergistic Effect on the Strength Characteristics of Modified Red Mud-Based Stabilized Soil

Experimental Study on a Dredged Fill Ground Improved by a Two-Stage Vacuum Preloading Method

Experimental Study on Performances of Silty Clay Stabilized by Solidification Agent

Laboratory Test Study of Properties of Expansive Soil Improved by Waste Foundry Sand

Cementitous material based stabilization of soft soils by stabilizer: Feasibility and durabiliy assessment