Abstract:Potential energy curves of BH((1) Sigma) and AlH((1)Sigma) molecules in their ground electronic states were calculated at RQCISD(T), UQCISD(T), BCCSD(T), UCCSD(T) and CASSCF (with four active electrons in five active orbitals) theoretical levels, Basis sets examined were 6-311 +G (3 df, 2p), G3 large, aug-cc-pVDZ and aug-cc-pVTZ and the bond lengths tested were up to 1.0 nm: Potential energy curves of BF((1)Sigma) and AlF((1)Sigma) were also examined at MP4/aug-cc-pVDZ level. It was shown that the MPn (n = 2 - 4) curves for BH, AlH and BF were seriously in error. in accordance with CASSCF wavefunctions, the single Hartree-Fock reference state was insufficient to describe the electronic structure of these molecules. In this case, the Hartree-Fock energy gaps between the LUMO and HOMO orbitals for these molecules were decreased when the bond distances were increased. By examination of the molecular orbital integrals, it was found that the interaction (integral values) between HOMO and LUMO orbitals increased greatly. As in the case of second-order MP perturbation calculations, the "stronger interaction" and the "smaller energy gap" resulted in too large correlation energy corrections and therefore led to serious errors in the total electronic energy. This predicted clearly that the MPn extrapolation technique in the widely used G1, G2, G3 and CBS series accurate model chemistry was not reliable in general if the molecule is not at its equilibrium geometry, as what in the study of chemical reaction paths. However, QCISD(T) calculations reflected approximately the correct potential energy curves and more reliable dissociation limits. The maximum error, 40.6 kJ.mol(-1), of dissociation energy at the bond length of 1.0 nm was found in AlH molecule by the G2 basis sets 6-311 + G(3 df, 2p). The CCSD(T) was also found less reliable than the QCISD(T) method in describing the dissociation energies. The same error was 101.9 kJ.mol(-1). All of the results in this work suggested the non-extrapolation G2(QCI) be more reliable a method in the energy calculations of non-equilibrium structure of molecules and be more valuable in further developments and modifications to the methods of accurate model chemistry.

A Correlation Potential Method For Electron Scattering Total Cross Section Calculations On Several Diatomic And Polyatomic Molecules Over Energy Range 10 Similar To 5000 Ev

A Correlation Potential Method for Electron Scattering Total Cross Section Calculations on Several Diatomic and Polyatomic Molecules over Energy Range 10∼5000 eV

Total Cross Sections for Electron Scattering from the Isoelectronic ( Z = 14) Molecules (C 2 H 2 , CO, HCN and N 2 ) at 100–5000 Ev

Total cross sections for scattering of electrons from O-2, H2O, H-2, O-3 CO and CO2 at 100-2000eV

Total Cross Sections for Scattering of Electrons from the Isoelectronic (Z=10) Molecules (CH4, H2O, HF and NH3) at 100～5 000 Ev

A modification potential method of calculating total cross sections of electrons scattering from complex molecules C 2 H 6 , C 2 F 6 , C 6 H 6 and C 6 F 6 at 100 eV–5000 eV

Differential, Elastic Integral and Moment Transfer Cross Sections for Electron Scattering from N 2 at Intermediate- and High-Energies

Total Cross Sections for the Scattering of Electrons from Methane and Chloromethanes at Intermediate and High Energies

Electron Scattering by O2 at Intermediate and High Energies

Absolute Differential Cross Sections for Elastic Scattering of Electrons from CO at Intermediate and High Energies

Total Cross Sections For Electrons Scattering From Simple Molecules Containing The Larger Atom Sulfur At 30-5000ev

Absolute Differential, Elastic Integral and Moment Transfer Cross Sections for Electron Scattering from O2 and CF4 at Intermediate- and High-Energies

Absolute Differential, Elastic Integrated and Moment Transfer Cross Sections for Electron–ocs Collisions at Intermediate and High Energies

A New Semi-Empirical Method for Total Cross Sections of Electron Scattering from Spherical Polyatomic Molecules at 30-5000 Ev

Total Cross Sections for Elastic Scattering of Electrons from Fluoromethanes in the Intermediate and High Energy Range

Electron Scattering by C4h10 and C6h6 in the Energy Range 100-1000 Ev

Differential Cross Sections Of Elastic Electron Scattering From Ch4, Cf4 And Sf6 In The Energy Range 100-700 Ev

Low-energy Electron Scattering with H2O and NH3 Molecules.

Single-reference Moller-Plesset perturbation extrapolation technique in the accurate model chemistry is unreliable for non-equilibrium molecules

Calculation of Scattering Cross Section of the Electron and the Second Period Element Atom

Electron Scattering Cross Sections from NH3: a Comprehensive Study Based on R-matrix Method