Ballistic Performance of B4C/Al2O3 Composite Ceramic Prepared by Reaction Sintering
Sun Chuan,Wan Chun-Lei,Pan Wei,Zong Peng-An,Li Yun-Kai,Zhou Shi-Meng,C Sun,CL Wan,W Pan,PA Zong,YK Li,SM Zhou
DOI: https://doi.org/10.15541/jim20170304
IF: 1.292
2018-01-01
Journal of Inorganic Materials
Abstract:Dense B4C ceramic matrix composites were synthesized by reactive hot press sintering at the temperature of 1800 degrees C and the pressure of 35 MPa using commercial available B2O3, Al, graphite, and B4C as raw materials. Micro structure, phase composition and mechanical properties were observed and tested. The composite ceramics were penetrated by a 7.62 mm calibre armor-piercing bullet at restrained and unrestrained states. Then the protection factor was calculated according to the rules of DOP method. In comparison, the ballistic performances of AZ ceramic and monolithic B4C were also investigated. The results indicated that the mam phase of the as-prepared sample was B4C (similar to 70wt%) and the secondary phase was A1(2)O(3). A complex intermediate phase contained Al-B-O was found filled in the holes between the main phase and the secondary phase. Density, hardness, bending strength and fracture toughness of the composite were 2.82 g/cm(3), 41.5 GPa, 380 Mpa, and 3.9 MPa center dot m(1/2), respectively. The fracture toughness significantly increased by 85.7s% as compared with that of the pure B4C (2 1 MPa center dot m(1/2)). The protection factor of the composite ceramic gets 11% and 70% increase compared to those of AZ ceramic and monolithic B4C, respectively. At restrained states, the protection factors of all the samples are further improved by about 10%. These results suggested that B4C/A1(2)O(3) composite ceramic prepared by reactive hot press sintering method might be a good ceramic armor material.